Star Trac 7700, 7600 manual Daily

Page 13

DAILY

Clean

￿Use a 5:1 dilution ratio (5 parts water to1 part Simple Green￿, Formula 409￿, Fantastic￿,or the like).

+=

(5 parts water)

(1 part cleaner)

Apply cleaning solution to a clean cloth then wipe the following areas (Do not spray directly onto surfaces):

oDisplay (Keypad)

oHeart Rate Grips

oHandrails

oShroud

oSide Bed Covers

oUnder Belt Edge

Inspect

￿Inspect running belt for proper alignment (see Running Belt section for adjustment)

￿Inspect for wear and tear on exterior parts to include:

o Side stop switch for function o Shroud, housing and other

plastics for damage

o Running belt seam for tears or splits

11

Service Manual: E-TR and E-TRi

Image 13
Contents Pro Tread AC 7600 Asia/Middle East EuropeEspañol Table of Contents Maintenance Mode Page Electrical Safety Precautions SafetyEquipment Placing Objectives Power ElectricityUSA Wire Wire ConfigurationsEuropean Wire HOT Neutral GroundPower Cords Overview Preventive MaintenancePreventive Maintenance Schedule Daily Weekly Monthly Running Belt Running Belt Do Not’s Importance of Running Belt MaintenanceCleaning Procedure Clean Between Deck & Belt Cleaning a Running BeltClean Belt Surface Clean Sidebed CoversParts Required Running Belt TensionTools Required FrequencyRunning Belt Retension Procedure Be careful to ensure the Tail Roller does not Running Belt Alignment Cleaning Roller Care & MaintenanceRoller do NOT’s Parts Required Applying Wax to a Waxless Running BeltStep Step Engaging Maintenance Mode Maintenance ModeMaintenance Mode Keys Display Parameters Parameter DefaultsNo Rail Stop Parameter Setting Definitions SPEED3 Check with a Star Trac sales representative for definitions Display Test Maintenance Mode Test ModesCalibrate Scale Csafe Test Auto-Calibration Maintenance Mode Auto CalibrationLast Stat Last Error List DefinitionsDFR Information DFR’s Drive Fault RecordsUploaders Software DisplayTools Required Time RequiredSoftware Required on your PC Obtaining the Fisp and Latest Software Extracting Unzipping the Zip Files Connecting the USB Cable to the PC If a ‘Security Warning’ window appears Click ‘Run’ Project Change Point Uploading the Software into the UploaderReturn to Project Change Point Software MCB Uploading Software into the AC MCB with MCB Uploader Set Up Procedure for Programming modePage Uploading to the MCB Setting Back To Run ModePage Part Replacement Procedures Frequency Recommended Preventative Maintenance Running Belt Tensioning ProcedureStep When finished, remove the tape from the running belt Toll Free 714-669-1660 Tel Table Of Troubleshooting Documents TroubleshootingCheck Speed System and Check Motor System DFR Code 1000000, 100000 DFR Code DFR Code DFR Code 800 DFR Flowchart For # DFR Code 40, 20 DFR Remaining Codes Slipping Running Belt This page intentionally left blank Doc Rev B