Star Trac 7700, 7600 manual Equipment Placing

Page 7

EQUIPMENT PLACING

Star Trac recommends that treadmills be spaced a minimum of 20.0 inches (0.5 m) apart to allow safe and easy ingress and egress. More importantly, there must be at least 48 inches (1.25 m) of free space behind the treadmill.

The Pro Series treadmill measures: 85.5” l by 34.0” w (217 x 86.5cm). See the following graph for proper equipment spacing requirements:

￿ 20.0 ￿ inches (0.5 m)

￿ 20.0 ￿ inches (0.5 m)

￿ 20.0 ￿ inches (0.5 m)

￿ 20.0 ￿

￿ 20.0 ￿

￿ 20.0 ￿

￿ 20.0 ￿

inches

inches

inches

inches

(0.5 m)

(0.5 m)

(0.5 m)

(0.5 m)

￿ 48.0 ￿ inches (1.25 m)

￿ 48.0 ￿ inches (1.25 m)

￿ 48.0 ￿ inches (1.25 m)

5

Service Manual: E-TR and E-TRi

Image 7
Contents Pro Tread AC 7600 Asia/Middle East EuropeEspañol Table of Contents Maintenance Mode Page Electrical Safety Precautions SafetyEquipment Placing Objectives Power ElectricityHOT Neutral Ground Wire ConfigurationsUSA Wire European WirePower Cords Overview Preventive MaintenancePreventive Maintenance Schedule Daily Weekly Monthly Running Belt Running Belt Do Not’s Importance of Running Belt MaintenanceClean Sidebed Covers Cleaning a Running BeltCleaning Procedure Clean Between Deck & Belt Clean Belt SurfaceFrequency Running Belt TensionParts Required Tools RequiredRunning Belt Retension Procedure Be careful to ensure the Tail Roller does not Running Belt Alignment Cleaning Roller Care & MaintenanceRoller do NOT’s Parts Required Applying Wax to a Waxless Running BeltStep Step Engaging Maintenance Mode Maintenance ModeMaintenance Mode Keys Display Parameters Parameter DefaultsNo Rail Stop Parameter Setting Definitions SPEED3 Check with a Star Trac sales representative for definitions Display Test Maintenance Mode Test ModesCalibrate Scale Csafe Test Auto-Calibration Maintenance Mode Auto CalibrationLast Stat Last Error List DefinitionsDFR Information DFR’s Drive Fault RecordsUploaders Software DisplayTools Required Time RequiredSoftware Required on your PC Obtaining the Fisp and Latest Software Extracting Unzipping the Zip Files Connecting the USB Cable to the PC If a ‘Security Warning’ window appears Click ‘Run’ Project Change Point Uploading the Software into the UploaderReturn to Project Change Point Software MCB Uploading Software into the AC MCB with MCB Uploader Set Up Procedure for Programming modePage Uploading to the MCB Setting Back To Run ModePage Part Replacement Procedures Frequency Recommended Preventative Maintenance Running Belt Tensioning ProcedureStep When finished, remove the tape from the running belt Toll Free 714-669-1660 Tel Table Of Troubleshooting Documents TroubleshootingCheck Speed System and Check Motor System DFR Code 1000000, 100000 DFR Code DFR Code DFR Code 800 DFR Flowchart For # DFR Code 40, 20 DFR Remaining Codes Slipping Running Belt This page intentionally left blank Doc Rev B