Uploading Software into the AC MCB with MCB Uploader
The following procedure explains how to upload software into the MCB (Motor Control Board) of the AC Pro Treadmill. The software may be downloaded from the Star Trac Support Website http://support.startrac.com. Click on the Service Provider tab at the top then click on the Latest Product Software link.
Time Required
10 minutes
Parts Required
Uploader kit part number
Black uploader box
RS232 cable
Power cable
Tools Required
Phillips head screw driver
CAUTION: DO NOT TOUCH THE MOTOR CASE WITH THE POWER ON. THE CASE OF THE
MOTOR IS LIVE IN THE CIRCUIT AND CAN RESULT IN ELECTRICAL SHOCK
Set Up Procedure for Programming mode
1. | Turn the treadmill off at the on/off switch. |
2. | Remove the motor shroud. |
3. | Locate the RS232 connector on the MCB it is labeled J1 RS232 |
Fig 1 | at the top left corner of the MCB (see Fig 1 - Arrow 1) |
| |
4. | Locate the display cable connector at the top of the MCB. |
| Unplug the display cable (see Fig 1 - Arrow 2) |
5. | Locate the Jumpers JP1 and JP2 they are just below the RS232 |
| connector on the MCB (see Fig 1 - Arrow 3) |
CAUTION: Be very careful when unplugging the jumpers. It is very easy to drop them. If you do drop them, find them immediately as the treadmill can not run or be programmed without them.
46 | Service Manual: |