Star Trac 7600, 7700 manual Uploading to the MCB, Setting Back To Run Mode

Page 50

Fig 6

Fig 7

Fig 8

Uploading to the MCB

1.Turn the treadmill on at the on/off switch.

2.Turn the treadmill power on. After 2 to 3 seconds the RED led on the uploader should light steady (see Fig 6)

3.Press the RED button once. The Led’s should blink on and off then one led will remain lit.

If the RED led is on, the upload did not work.

￿Check all connections and verify the jumper settings then repeat the procedure.

If the GREEN led is on, the upload was successful, proceed to the next step.

Setting Back To Run Mode

1.Turn the power off at the on/off switch.

2.Move the jumpers back to their original run position (see Fig 8).

3.Unplug the RS232 cable from the mcb.

4.Unplug the uploader power cable from the mcb and plug the display cable of the treadmill in.

5.Unplug JP1 and move it down one pin so it is connected to the bottom two pins and the top pin is exposed.

6.Unplug JP2 and move it up one pin so it is now connected to the top two pins and the bottom pin is exposed.

Jumpers in RUN mode

48

Service Manual: E-TR and E-TRi

Image 50
Contents Pro Tread AC 7600 Español EuropeAsia/Middle East Table of Contents Maintenance Mode Page Precautions Safety Electrical SafetyEquipment Placing Power Electricity ObjectivesEuropean Wire Wire ConfigurationsUSA Wire HOT Neutral GroundPower Cords Preventive Maintenance OverviewPreventive Maintenance Schedule Daily Weekly Monthly Running Belt Importance of Running Belt Maintenance Running Belt Do Not’sClean Belt Surface Cleaning a Running BeltCleaning Procedure Clean Between Deck & Belt Clean Sidebed CoversTools Required Running Belt TensionParts Required FrequencyRunning Belt Retension Procedure Be careful to ensure the Tail Roller does not Running Belt Alignment Roller do NOT’s Roller Care & MaintenanceCleaning Step Applying Wax to a Waxless Running BeltParts Required Step Maintenance Mode Engaging Maintenance ModeMaintenance Mode Keys Parameter Defaults Display ParametersNo Rail Stop Parameter Setting Definitions SPEED3 Check with a Star Trac sales representative for definitions Maintenance Mode Test Modes Display TestCalibrate Scale Csafe Test Maintenance Mode Auto Calibration Auto-CalibrationLast Error List Definitions Last StatDFR’s Drive Fault Records DFR InformationSoftware Display UploadersSoftware Required on your PC Time RequiredTools Required Obtaining the Fisp and Latest Software Extracting Unzipping the Zip Files Connecting the USB Cable to the PC If a ‘Security Warning’ window appears Click ‘Run’ Uploading the Software into the Uploader Project Change PointReturn to Project Change Point Software MCB Set Up Procedure for Programming mode Uploading Software into the AC MCB with MCB UploaderPage Setting Back To Run Mode Uploading to the MCBPage Part Replacement Procedures Running Belt Tensioning Procedure Frequency Recommended Preventative MaintenanceStep When finished, remove the tape from the running belt Toll Free 714-669-1660 Tel Troubleshooting Table Of Troubleshooting DocumentsCheck Speed System and Check Motor System DFR Code 1000000, 100000 DFR Code DFR Code DFR Code 800 DFR Flowchart For # DFR Code 40, 20 DFR Remaining Codes Slipping Running Belt This page intentionally left blank Doc Rev B