MAINTENANCE MODE – AUTO CALIBRATION
Electrical voltages vary between locations. The treadmill can run through an
To run an
Auto-Calibration
DO NOT LEAVE THE TREADMILL UNATTENDED WHILE RUNNING
THE
BELT TO THE MAXIMUM SPEED SETTING.
1.Enter the Maintenance Mode (see “Engaging Maintenance Mode”). The display will read:
2.Enter the Motor test mode by pressing the ‘8’ key once. The display will read:
3.Start the
The center number (3) as shown above, will begin to increase, running belt will move and the center number will on the right hand side of the display (0.0) will move .
The treadmill running belt will begin to move in the following manner:
Running belt will move, center number will increase and the numbers on the right hand side of the display ‘0.0’ will move
34 | Service Manual: |