2.Insert the Right Upright (74) into the indicated bracket on the Base (83); be careful not to dislodge the Cage
Nuts (76) from the Right Upright (see the inset draw- ing). In addition, be careful not to pinch the Upright Wire Harness (75). Finger tighten three Upright Bolts (72) with three Washers (78) and three Upright Star Washers (71) into the Right Upright and the bracket. Do not tighten the Upright Bolts yet.
Repeat this step with the Left Upright (not shown). Note: There is not a wire on the left side.
3.Attach the Catch (5) to the left side of the Frame (48) with two 3/4” Screws (4).
With the help of a second person, raise the Frame (48) to a vertical position. Be careful not to raise the Frame past the vertical position. Have the other person hold the Frame until step 5 is completed.
4.Hold the cylinder end of the Shock (88) near the bracket in the center of the Frame (48).
See the two small inset drawings. Using your fingernail or the end of a screwdriver, press on the end of the Shock Pin (102) to loosen it from the Shock (88). Next, rotate the Shock Pin and pull it out of the Shock. Be careful to avoid losing the Shock Pin.
Orient the Shock (88) so it is in the position shown. Press the end of the Shock onto the ball on the bracket.
See drawing 4a. Insert the Shock Pin (102) into the two indicated small holes in the end of the Shock (88). Then, rotate the Shock Pin until it clips onto the Shock. Note:
Extra Shock Pins are included.
2 | 75 |
|
|
|
|
| |
| 74 |
|
|
|
| 78 | 72 |
|
| 71 |
|
| 78 |
|
|
| 72 |
|
|
| 76 |
|
|
|
| 83 |
|
| 71 | Bracket |
|
|
|
| |
3 |
|
|
|
|
| 4 | 5 | 48 |
|
|
| ||
|
|
|
| |
4 | Cylinder |
|
| 102 |
|
|
| ||
| 88 |
| 48 |
|
| Bracket | 102 | ||
|
|
|
| |
| 102 |
|
|
|
4a |
|
| 88 |
|
|
|
|
| |
| 102 |
|
|
|
| Hole |
|
| Bracket |
|
| Hole |
| |
7