INTRODUCTION
A S S E M B LY STEP 2
IMPORTANT PRECAUTIONS
HARDWARE BAG FOR STEP 2 CONTENTS :
FLAT WASHER (E)
16mm Qty: 2
BOLT (F)
20mm Qty: 2
A)Open HARDWARE BAG FOR STEP 2.
B)Slide FOOT LEVELER AXLE through MAIN FRAME TUBE. (The FOOT LEVELER AXLE is on top of bottom styrofoam, beside the side shroud).
ASSEMBLY
BEFORE YOU BEGIN
| MAIN FRAME |
| FLAT WASHER (E) |
FOOT LEVELER AXLE | BOLT (F) |
| FOOT LEVELER |
C)Slide left and right FOOT LEVELERS onto MAIN FRAME.
D)Attach FOOT LEVELERS using a WASHER (E) and BOLT (F) on each side of the MAIN FRAME.
ELLIPTICAL OPERATION
A S S E M B LY STEP 3
HARDWARE BAG FOR STEP 3 CONTENTS : |
| A) Open HARDWARE BAG FOR STEP 3. | ||
|
| SCREW (G) | B) (For Model 4.3E only) Fit RUBBER PAD | |
|
| |||
|
| 12 mm | into bottom of FOOT PAD with traction | |
|
| Qty: 8 | ||
|
| nubs facing up. | ||
|
|
|
| |
CONDITIONING TROUBLESHOOTING LIMITED
GUIDELINES & MAINTENANCE WARRANTY
FOOT PAD |
|
RUBBER PAD | LOWER LINK ARM PLATE |
(4.3E only) | |
| SCREW (G) |
C)Attach FOOTPAD to LOWER LINK ARM PLATE using 4 SCREWS (G).