PROBLEM: The walking belt is |
|
|
|
SOLUTION: a. If the walking belt is |
|
|
|
UNPLUG THE POWER CORD. If the walking belt |
| a |
|
has shifted to the left, use the hex key to turn the |
|
|
|
|
|
| |
left idler roller bolt clockwise 1/2 of a turn; if the walk- |
|
|
|
ing belt has shifted to the right, turn the left idler |
|
|
|
roller bolt counterclockwise 1/2 of a turn. Be careful |
|
|
|
not to overtighten the walking belt. Plug in the power |
|
|
|
cord, insert the key, and run the treadmill for a few |
|
|
|
minutes. Repeat until the walking belt is centered. |
|
|
|
|
|
| |
b. If the walking belt slips when walked on, first remove |
|
|
|
| b | ||
the key and UNPLUG THE POWER CORD. Using |
| ||
the hex key, turn both idler roller bolts clockwise, 1/4 |
|
|
|
of a turn. When the walking belt is correctly tight- |
|
|
|
ened, you should be able to lift each edge of the |
|
|
|
walking belt 3 to 4 in. (8 to 10 cm) off the walking |
|
|
|
platform. Be careful to keep the walking belt cen- |
|
|
|
tered. Then, plug in the power cord, insert the key, |
|
|
|
and carefully walk on the treadmill for a few minutes. |
|
|
|
Repeat until the walking belt is properly tightened. |
|
|
|
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds, reinsert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.
24