76
Display” button to switch the
treadmill on. Use the "SELECT DISPLAY" button to switch
into elevation mode (both the "TIME" and "DISTANCE"
LED’s will be lit).
STEP | Lower the treadmill until it is level |
3:(o% elevation).
STEP | Turn the elevation potentiometer until "168" (* |
4:153 Sprint 2)
shows in the display.If the number in the display does not change
as the pot is turned, the pot is broken and must be replaced
(check with an ohmmeter to verify)
STEP | Carefully push the potentiometer back into the |
5:elevation
motor and tighten it back down. Be careful that the reading
on the display does not change while the pot is being
re - installed. Turn the machine off, turn it back on
normally, and verify that the elevation system works correctly.
TRACKING AND TENSIONING
Proper tensioning of the Treadbelt and Drive Belt are necessary to insure smooth operation and long life for your treadmill. As these components may stretch as part of their normal break in period it is one of the few things we ask our customers to do in