Landice 8700 manual Elevation system will need to

75

MAX MIN IR CL

STEP 2: Turn machine on, increase speed until 1.2 mph shows on display,

then slowly decrease speed just until the display shows exactly 1.0 mph.

STEP 3: Adjust "MIN" pot on KBLC-118 until belt speed is between

0.95- 1.00 mph using a tachometer OR

8.8- 9.3 rpm counting belt revolutions.

STEP 4: Turn speed up to 8.8 mph ( on display ), then slowly increase

speed just until display shows

exactly 9.0 mph.

STEP 5: Adjust "MAX" pot on the KBLC-118 until the belt speed is between

8.95- 9.00 mph ( or

83.0- 83.4 rpm ).

STEP 6: Since the "MAX" and "MIN" pots will affect each other during the

adjustment, it may be nessary to repeat steps 2 - 5 several times.

Continue calibration until neither pot needs readjustment.

	Appendix 2: Elevation System Calibration
Note:	The elevation system will need to
	be re - calibrated:
	1.	After replacing the elevation
	motor.
	2.	After replacing the elevation
	potentiometer.
	3.	If the elevation readout appears
	inaccurate.
STEP	Remove the two screws holding the elevation

1:potentiometer

and pull the pot from the back of the elevation motor.

STEP	Turn	the treadmill on in	the diagnostic
2:	mode	by holding down the	“ Select