Healthrider T90 manual Basic Television Operation, HOW to Memorize Channels

BASIC TELEVISION OPERATION

1 Insert the key fully into the console.

See GETTING STARTED on page 11.

2 Press the Power button below the television to turn on the television.

When the button is pressed, the channel display will light and show the most re- cently selected channel.

3 Press the Channel buttons to select the desired channel.

To change the channel, press the Channel but- tons. Note: The television is equipped with a channel memorizing function that allows you to step up or down from the current channel to the next channel set into memory. Before channels can be selected in this way, they must be set into the television’s memory. See HOW TO MEMO- RIZE CHANNELS at the right.

4 Press the Volume buttons to adjust the volume.

When the Volume buttons are pressed,

the selected volume level will appear in the channel display

for a few seconds. There are 11 volume

levels (0 though 10). Note: To use earphones or headphones (not included), plug them into the jack below the console.

5 When you are finished using the television, press the Power button below the television.

When the button is pressed, the channel display will darken.

6 When you are finished using the treadmill, re- move the key.

Remove the key from the console and put it in a secure place. Next, move the on/off switch near the power cord to the off position and unplug the power cord.

HOW TO MEMORIZE CHANNELS

Follow the steps below to set channels into the televi- sion’s memory.

1 Press the Stop button while inserting the key fully into the console.

The console will turn on and the information mode/ demo mode will be selected. (See THE INFOR- MATION MODE/DEMO MODE on page 21.)

2 Press the Stop button and set the television for a cable connection or an antenna connection.

When the button is pressed, the letters cAbL (cable) or Air will appear in the Time/Pace display. If you have connected

a CATV cable to the treadmill, cAbL should be se- lected. If you have connected an antenna, Air should be selected. Press the Power button below the television to change the setting, if necessary.

3 Press the Channel + button to scan and memorize channels.

When the button is pressed, the television will begin scanning all of the channels available in your area. When no broadcast signal is detected on a channel, the channel will be skipped. When a signal is detected, the channel will be stored in memory, a tone will sound, and the next channel will be selected. This process will be repeated until the highest channel is reached. A series of tones will then sound.

4 Press the Stop button and erase or add channels.

After all valid channels available in your area have been set into memory, you can erase unwanted channels or manually add channels.

To erase a channel, first press the Channel buttons until the unwanted chan- nel appears in the channel display. The

letters dEL (delete) will appear in the Time/Pace display. Press the Power button below the televi- sion to delete the channel.