Healthrider HRTL20510.1 manual Tie s Bracket

Page 10

7.With the help of a second person, hold the con- sole assembly near the Left Upright (88).

Route the Upright Wire (77) around the indicated crossbar. Then, route the Upright Wire through the looped ties on the bottom of the console as- sembly.

Connect the Upright Wire (77) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-

NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER.

8.Set the console assembly on the brackets onBe the Left and Right Uprights (88, not shown). careful not to pinch any wires.

Attach the console assembly with four 5/16" x 1 1/4" Patch Screws (4) and four 5/16" Star Washers (11) (only one side is shown). Start all four Patch Screws, but do not tighten them until assembly step 12 is completed.

Insert the excess Upright Wire (77) into the hole in the console assembly. Tighten the ties around the Upright Wire and cut off the ends of the ties.

7		Console
		Assembly
Console		Crossbar
Wire	77	Ties

Console	88
Console
Wire
77
8	Console
	Assembly
77	Ties	Bracket
77	Ties
	11	88
	4	88

10

Image 10

Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. HRTL20510.1 Serial No On the WEBTable of Contents Important Precautions Save These InstructionsBefore YOU Begin Part Identification Chart Ing materials until you finish assembly AssemblyAssembly requires two persons Packing materials. Do not dispose of the packUpright 88 do not fully tighten the Patch See the inset drawing. Tie the wire tieAttach the Right Upright not shown Page Tie s Bracket Pulse Wire Page Side is shown do not tighten the Patch Screws yet Raise the Frame 57 to the position shown Page Care and Maintenance HOW to USE the Chest Pulse SensorHOW to PUT on the Chest Pulse Sensor TroubleshootingHOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to SET UP the ConsoleBegin working out HOW to USE the Manual ModeInsert the key into the console Page Measure your heart rate if desired COOL-DOWN ModeTurn on the fan if desired HOW to USE AN Onboard Workout Start the workoutHOW to USE AN Ifit Live Workout Ifit Live FCC Information HOW to USE the Internet Browser HOW to USE the Settings Mode Select the wireless network modeSelect a language Exit the settings modeLog in to your iFit Live account Select the unit of measurementHOW to USE the Maintenance Mode Select the settings mode. See on Select the maintenance modeView technical information HOW to USE the Stereo Sound System HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Lower the Treadmill for USETroubleshooting Symptom The power turns off during useSymptom The iFit Live mode does not function correctly Symptom The walking belt slows when walked onPage Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches Part List Key No. Qty DescriptionQty Exploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT