Healthrider HRTL20510.1 manual Assembly requires two persons

ASSEMBLY
• To hire a service technician to assemble this	•	To identify small parts, see page 6.
product in your home, call 1-800-445-2480.	• Assembly requires the following tools:
• Assembly requires two persons.
		the included hex keys
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the pack-		one adjustable wrench
ing materials until you finish assembly.		one Phillips screwdriver
• The underside of the walking belt is coated with
high-performance lubricant. After shipping, there		scissors
may be some lubricant on top of the walking belt		needlenose pliers
or on the shipping carton. This is normal. If there
is lubricant on top of the walking belt, wipe it		To avoid damaging parts, do not use power
off with a soft cloth and a mild, non-abrasive
cleaner.		tools for assembly.
Make sure that the power cord is unplugged.	1
Place a piece of cardboard below the rear of the
Frame (57) to protect the floor or carpet.
Attach the Left Wheel Cap (92) to the Base (91)
with two #8 x 3/4" Screws (2).
Attach the Right Wheel Cap (not shown) to
the right side of the Base (91) in the same		91
way.			2
					57
				92 Cardboard
2. Pull the Upright Wire (77) and the Ground Wire	2
(90) through the indicated hole in the Base (91).
Attach the Ground Wire (90) to the Base (91)
with a #8 x 1/2" Ground Screw (10).			Hole
		77
			10	90	91
	7