Healthrider HRTL20510.1 manual Ifit Live FCC Information

Page 25

When you select an iFit Live workout, the screen will show the name, duration, and distance of the workout. The screen will also show the approxi- mate number of calories you will burn during the workout. If you select a competition workout, the display will count down to the beginning of the race.

5.Start the workout.

See step 4 on pages 23 and 24.

During some workouts, the voice of a personal trainer will guide you through your workout.

6.Monitor your progress.

See step 5 on page 21. The screen may also show a map of the trail you are walking or running. During a competition workout, the screen will show the speeds of the runners and the distances they have run. The screen will also show the numbers of seconds that the other runners are ahead of you or behind you.

7.Measure your heart rate if desired. See step 6 on page 22.

8.Turn on the fan if desired. See step 7 on page 22.

9.When you are finished exercising, remove the key from the console.

See step 8 on page 22.

For more information about the iFit Live mode, go to www.iFit.com.

IFIT LIVE FCC INFORMATION

IMPORTANT: To comply with FCC and IC RF expo- sure compliance requirements, the antenna used for this transmitter must be installed to provide a

separation distance of at least 20 cm from all per- sons and must not be co-located or operating in conjunction with any other antenna or transmitter.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation. This equipment gener- ates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the in- structions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is en- couraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit dif- ferent from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV tech- nician for help.

FCC CAUTION: To assure continued compliance, use only shielded interface cables when connect- ing to computer or peripheral devices. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired opera- tion.

If you have questions after reading this information, please call Customer Care toll-free at 1-866-608-1798, Mon.–Fri. 6 a.m.–6 p.m. MT, Sat. 8 a.m.–4 p.m. MT (closed on holidays); visit www.iFit.com/support; or send e-mail to service@iconfitness.com.

25

Image 25
Contents Model No. HRTL20510.1 Serial No QUESTIONS?Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Instructions Save TheseBefore YOU Begin Part Identification Chart Assembly requires two persons AssemblyIng materials until you finish assembly Packing materials. Do not dispose of the packUpright 88 do not fully tighten the Patch See the inset drawing. Tie the wire tieAttach the Right Upright not shown Page Tie s Bracket Pulse Wire Page Side is shown do not tighten the Patch Screws yet Raise the Frame 57 to the position shown Page HOW to PUT on the Chest Pulse Sensor HOW to USE the Chest Pulse SensorCare and Maintenance TroubleshootingHOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to SET UP the Console HOW to Turn on the PowerBegin working out HOW to USE the Manual ModeInsert the key into the console Page Measure your heart rate if desired COOL-DOWN ModeTurn on the fan if desired Start the workout HOW to USE AN Onboard WorkoutHOW to USE AN Ifit Live Workout Ifit Live FCC Information HOW to USE the Internet Browser Select the wireless network mode HOW to USE the Settings ModeLog in to your iFit Live account Exit the settings modeSelect a language Select the unit of measurementSelect the settings mode. See on Select the maintenance mode HOW to USE the Maintenance ModeView technical information HOW to USE the Stereo Sound System HOW to Fold the Treadmill HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USESymptom The power turns off during use TroubleshootingSymptom The walking belt slows when walked on Symptom The iFit Live mode does not function correctlyPage Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Key No. Qty Description Part ListQty Exploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT