Healthrider HRTL20510.1 manual See the inset drawing. Tie the wire tie

3. Identify the Left Upright (88), which is marked	3					Wire Tie
with a “Left” sticker. Have a second person hold					77
the Left Upright near the Base (91).						88
See the inset drawing. Tie the wire tie in the
Left Upright (88) securely around the Upright						77
Wire (77) about 8 in. (20 cm) down from the
end. Then, pull the other end of the wire tie until
the Upright Wire is routed completely through					Wire
the Left Upright. Note: The Upright Wire should
bend so that the connectors are pointing down-					Tie
ward.
		88
					77	91
4. Hold the Left Upright (88) against the Base	4
(91). Be careful not to pinch the Upright
Wire (77) or the Ground Wire (90). Insert two
3/8" x 2 3/4" Patch Screws (7) and two 3/8" x
1 1/4" Patch Screws (8) with two 3/8" Star						88
Washers (13) into the Left Upright.
Partially tighten the 3/8" x 2 3/4" Patch Screws
(7) and the 3/8" x 1 1/4" Patch Screws (8) until
the heads of the Patch Screws touch the Left
Upright (88); do not fully tighten the Patch
Screws yet. Note: It may be helpful to use the
Short Hex Key (110) on the Bolt shown.
Attach the Right Upright (not shown) in the				7
same way. Note: There are no wires on the						110
right side.
	8	13
	77, 90		8	13	91
	8