VDO Cyclecomputing Z3 PC-LINK ‚ „NAVIGATOR Next Digit, ‚ Navigator ?SET OK?, ‚ Navigator SET Done

EN

through)

‚„NAVIGATOR NEXT DIGIT

... repeat for all digits from back to front

‚NAVIGATOR ?SET OK?

∂ƒ Set first digit (keep button depressed for fast run- through)

‚NAVIGATOR SET DONE

Automatic return to the operation mode for NAVIGATOR

12.2. RESETTING THE NAVIGATOR AT THE ORIENTATION POINT

3 sec.	√	TRIP DATA ?RESET?
	∂ ƒ	NAVIGATOR ?RESET?
	‚	NAVIGATOR ?RESET? <<?RESET?>> flashes
	‚	NAVIGATOR RESET DONE

Automatic return to the operation mode for NAVIGATOR Navigator reset done

13. THE TIMING FUNCTIONS

The following settings are of particular importance when using the pulse functions (chapter 14).

Your VDO computer has 6 different timing functions. If one of the timing functions is running the TIMING indicator iconwill always be flashing in the left part of the display. Moreover the residence times in the trai- ning ranges are captured for each running timing function (see chapter Kap. 14). The setting range/measuring range for all timing functions is 0:00:00 h to 24:00:00 h

TIMER 1: You can program a time e.g. for interval training. TIMER 1 counts from zero forward. At the end of TIMER 1 there is a single beep. Timer 1 only functions if you have set a time. If you have forgotten to set a time your VDO computer displays TIMER ERROR

TIMER 2: You can program a time, e.g. for the rest phase in an interval training. TIMER 2 counts from zero forward. At the end of TIMER 2 there are two beeps. Timer 2 only functions if you have set a time. If you have forgotten to set a time your VDO computer displays TIMER ERROR

TIMER 1+2 runs until you stop these functions. Timers 1 + 2 only function if you have set a time. If you have forgotten to set a time your VDO computer displays TIMER ERROR.

COUNTDOWN: You can program a time, the timer will count backwards from this time. At the end of the COUNTDOWN time there is a single beep. Countdown only functions if you have set a time. If you have forgotten to set a time your VDO computer will display COUNTDOWN ERROR.

LAP TIMER: Start Lap Timer with ∫ . Start next Lap with ≈ + ¥ at the same time at any point of the training unit. The following values will be saved:

32