8.Insert the Pivot Axle (21) into the Upright (2), and center the Pivot Axle. Apply a small amount of the included grease to both ends of the Pivot Axle.
Identify the Left Upper Body Arm (5), which is marked with a decal. Insert an Upright Bushing (20) into an Upright Spacer (19). Turn the Upright Spacer so that the semicircular cutout is at the top, and slide the Upright Spacer onto the post on the Left Upper Body Arm.
Slide the Left Upper Body Arm (5) onto the Pivot Axle (21). Attach a Pivot Spacer (17) to the Left Upper Body Arm with an M4 x 16mm
Slide a Small M8 Washer (71) onto an M8 x 19mm Shoulder Screw (102), and tighten the Shoulder Screw into the Pivot Axle (21).
Attach the Right Upper Body Arm (6) in the same way.
9.Apply a small amount of grease to the axle on the left Crank Arm (40).
Identify the Left Pedal Leg (28), which is marked with a decal. Slide the Left Pedal Leg onto the axle on the left Crank Arm (40). Next, slide a Wave Washer (101) onto the end of the axle. Then, slide a Large M8 Washer (70) onto an M8 x 25mm Patch Screw (73), and tighten the Patch Screw into the axle.
Snap a Pedal Cushion (74) around the Left Pedal Leg (28) onto a Cushion Bracket (99). Make sure that the arrow on the Pedal Cushion is pointing to one of the numbers on the Left Pedal Leg and that the num- ber shows through the window in the Cushion Bracket.
Assemble the Right Pedal Leg (not shown) in the same way.
10.Identify the Left Pedal Arm (33), which is marked with a decal. Attach the Left Pedal (35) to the Left Pedal Arm with two M6 x 20mm Screws (75) as shown.
Attach the Right Pedal (not shown) to the Right Pedal Arm (not shown) in the same way.
8
8 |
|
|
|
|
|
| 2 |
5 |
| 20 | 21 |
|
| ||
| 19 |
|
|
17 |
|
| Grease |
16 |
|
|
|
71 | Post | 6 | |
|
|
| |
102 |
|
|
|
82 |
|
|
|
9 |
|
|
|
74 |
|
|
|
|
|
| Grease |
|
|
| 28 |
| 99 |
| 40 |
|
|
| |
Window |
|
|
|
|
| 70 | 101 |
| 73 |
| |
10 |
| 75 |
|
|
|
| |
|
|
| 35 |
| 33 |
|
|