HOW to USE a Preset Program

1.Press any button on the console or begin pedaling to turn on the console.

See step 1 on page 15.

2.Select a preset program.

To select one of the four preset programs, press the Weight Loss, the Aerobic 1, the Aerobic 2, or the Performance button on the left side of the console.

When you select a preset program, the name of the program and the maximum resistance level will appear in the display for a few seconds. A profile of the resistance levels of the program will also scroll across the left side of the display.

3.Begin pedaling to start the program.

Each program is divided into 30 one-minute seg- ments. One resistance level and one target pace setting is programmed for each segment. Note:

The same resistance level and/or target pace set- ting may be programmed for consecutive seg- ments.

During the program, the program profile will show your progress (see the drawing above). The flashing segment of the profile represents the cur- rent segment of the program. The height of the flashing segment indicates the resistance level for the current segment. At the end of each seg- ment of the program, a series of tones will sound and the next segment of the profile will begin to flash. If a different resistance level is pro- grammed for the next segment, the resistance level will appear in the display for a few seconds to alert you. The resistance of the pedals will then change.

During the program, the program target pacer will prompt you to keep your pedaling pace near the target pace setting for the current segment. When a left indicator lights, increase your pace; when a right indicator lights, decrease your pace. When the center indicator lights, maintain your current pace. Important: The program target pacer is intended only to provide a goal. Make sure to pedal at a pace that is comfortable for you.

If the resistance level for the current segment is too high or too low, you can manually override the resistance level by pressing the OneTouch Resistance buttons. However, when the current segment ends, the resistance of the pedals will automatically adjust to the resistance level for the next segment.

If you stop pedaling for several seconds, a series of tones will sound and the program will pause. To restart the program, simply resume pedaling. The program will continue until the last segment of the program ends.

4.Follow your progress with the displays. See step 4 on page 15.

5.Measure your heart rate if desired. See step 5 on page 16.

6.Turn on the fan if desired. See step 6 on page 16.

7.When you are finished exercising, the console will turn off automatically.

See step 7 on page 16.