MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console displays become dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 9 on page 9 for replacement instructions.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper- ly, see step 5 on page 16.
HOW TO ELIMINATE RUBBING OF THE DISCS
If the Discs (12) rub against the Side Shields (14, 15) during use, make sure that the Center Foot (40) is installed in the Frame (1). If the Center Foot is installed, loosen the two indicated Bolt Sets (88) and the two M4 x 19mm Screws (81) in each side of the elliptical exerciser.
88 |
14, 15 |
1 |
12 |
40 |
81 |
Adjust the position of the Side Shields (14, 15) until the Discs (12) no longer rub against them, and then tighten the Bolt Sets (88) and the M4 x 19mm Screws (81).
HOW TO ADJUST THE BELT
If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the belt may need to be adjusted. To adjust the belt, first see assembly step 12 on page 11 and remove the left pedal arm and the left link arm.
Then, carefully |
| |
pry off the left |
| |
Disc Cover (13) |
| |
using a flat |
| |
screwdriver. Next, |
| |
remove the four |
| |
screws (not |
| |
shown) from the |
| |
center of the left | 13 | |
Disc (12). Gently | 12 | |
rotate the Disc | ||
| ||
Cover and the |
|
Disc away from the elliptical exerciser.
Loosen, but do |
| |
not remove, the |
| |
three indicated |
| |
screws (A). Insert | 74 | |
the shaft of a | ||
| ||
screwdriver | 47 | |
downward | ||
48 | ||
between the | ||
A | ||
Idler (47) and the | ||
Idler Pulley (48). |
| |
Pull the top of the |
| |
screwdriver |
| |
toward the front |
|
of the elliptical exerciser until the Belt (74) is tight. Then, tighten the three screws.
Reattach the left disc with the four screws and then reattach the left disc cover. Next, see assembly step 12 on page 11 and reattach the left pedal arm and the left link arm.
20