Printing mechanism
Inserting printer paper
1.Pull out the paper case at the bottom of the control unit and detach it.
paper case
2.Cut the edge of the thermal paper to a point with a scissors (as illus- trated).
cut
thermal paper
Pull |
| 6. Holding the edge of the thermal paper coming out of the paper |
| guide, pull it out and pass it under the printer cover. | |
|
| |
|
| Close the printer cover, and draw the paper until the paper edge |
|
| entirely comes out of the printer cover. |
| paper guide |
|
| RESET |
|
| MODE | 7. Insert the paper case completely into the bottom of the control unit. |
printer cover | ADV | |
| Then pull the thermal paper again to remove the paper sag in the | |
|
| |
|
| paper case. |
|
| This completes setting the thermal paper. |
|
| You can cut the thermal paper with the printer cover closed. |
What to do when printer paper gets jammed
printer cover | 1. Lift up the paper guide on the front panel of the control unit. |
| paper guide |
thermal paper face
3.Insert the paper roller into the paper roll, and place the roll in the case in the correct position and direction as illustrated.
Note: The printer will not print out data on the reverse side of the paper. Check the proper direction before inserting.
paper roller
RESET |
MODE |
ADV |
2. Use tweezers to remove the jammed paper.
4. Insert the paper case halfway into the bottom of the control unit (as illustrated below).
Insert
paper inlet
5.Then raise the printer cover and insert the pointed edge of thermal paper into the paper inlet of the control unit.
RESET
MODE
ADV
Caution on printer operation
• Do not drive the printer without the thermal paper on it. If the ther- mal paper is unavailable, press the printer 
button and confirm
that the printer symbol 
on the LCD is not lit up before use.
• Please use the specified Cateye thermal paper (part #7226502) only.
48 | 49 |