Let's assemble
1Mounting Front Leg
•Remove the leg plate from the main unit. (This plate will not be used for assembly.)
•Place the front leg (with casters) under the main unit as shown in figure and fasten screws securely with the hexagon wrench making sure nuts locate at the bottom of the leg.
hexagon wrench
front leg (with casters)
2Mounting Rear Leg
•Place the rear leg (with level ad- juster) under the rear support pipe as shown in figure and fasten screws securely with the hexagon wrench making sure nuts locate at the bottom of the leg.
rear support pipe
| 7 | 8 |
5 |
| |
| 6 |
3 |
| 4 | rear leg |
1 | 2 |
|
|
(with level adjusters)
3Mounting Seat and Handlebar
•Mount the seat to the seat pipe us- ing the large screws and the handlebar using the small ones.
small screws
spring washer
flat washer
seat
large screws
spring washer
flat washer
4Assembling Rear Frame
•Loosen and remove the seat height lock knob.
•Insert the rear support pipe into the socket of seat pipe. Select any height and tighten the knob.
seat height lock knob
rear support pipe
5Connecting Inner Pipe
•Lift up the seat lock pin and pull out the inner pipe by a proper length for easier connection.
Remove the 3 screws from the end of the inner pipe.
•Insert the inner pipe into the joint fitting of the main unit and fasten it securely with the 3 screws.
PULL
lock pin
SLIDE
joint fitting
screws
inner pipe
6 Mounting Pedals
•Attach the pedals to cranks using the spanner wrench #15.
•Be sure to install the pedal (R) on the right crank and (L) on the left crank to avoid cross threading.
spanner wrench #15
(L) FRONT (R)
nuts
nuts
handlebar
4
3
Caution: If the pedals are not attached firmly enough to the crank, they can an irritating noise. Be sure to attach them firmly.
2
5
6
1
6 | 7 |