Gold's Gym GGTL80608.0 manual Be careful not to pinch the wires. Reattach

Page 11

If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the re- ceiver included with the chest pulse sensor.

1.

Make sure that the power cord is unplugged.

91

 

 

 

Remove the indicated #8 x 1/2" Screw (1) and

Small

 

 

the Access Door (87) from the Console Back

 

Small

 

(91).

 

Screws

2. Connect the wire on the receiver to the indicated

 

Receiver

Cylinder

 

wire extending from the Console Back (91).

 

 

 

 

Hold the receiver so the small cylinder is ori-

 

 

87

 

ented as shown and is facing the Console

 

 

 

Back. Attach the receiver to the plastic posts on

 

 

 

 

the Access Door (87) with the two included

 

Wire

1

 

small screws.

 

3. Be careful not to pinch the wires. Reattach

 

 

 

 

the Access Door (87) with the #8 x 1/2" Screw

 

 

 

 

Screw (1). Discard the other wires included with

 

 

 

 

the receiver.

 

 

 

11

Image 11
Contents Model No. GGTL80608.0 Serial No QUESTIONS?Table of Contents Various factors, including the users move Important PrecautionsPulse sensor is not a medical device Page Before YOU Begin Assembly Nut the Wheel must turn freely. Discard Make sure that the power cord is unpluggedNot to pinch the Upright Wire Do not fully fold the Frame yetFully tighten the Bolts yet Be careful not to pinch the Upright WireNot Connected PROPERLY, the CON Power is Turned onSole MAY be Damaged When Power is Turned on Not Connected PROPERLY, the CON Sole MAY be Damaged WhenPull on the sleeve to make sure that it is Locked into place Not to pinch the wiresBe careful not to pinch the wires. Reattach PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerRun Measure your heart rate if desired Press the Start button to start the workout HOW to USE a Preset WorkoutSelect a preset workout Press the Start Workout button to start the workout HOW to USE the Custom Workout CenterSelect the Custom Workout Center Press the Start Fitness Test button to start the workout HOW to USE the Fitness Test WorkoutPut on the chest pulse sensor Select the fitness test workoutConnector is fully plugged HOW to USE the Sound SystemInsert an iFit card and select a workout HOW to USE AN Ifit CardOptional Chest Pulse Sensor Information ModeHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingTop Problem The walking belt slows when walked onProblem Solution Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Key No. Qty Description Part LIST-Model No. GGTL80608.0105 #8 x 2 Screw Userʼs Manual 106 Right Handrail Trim Exploded Drawing A-Model No. GGTL80608.0 R1108A Exploded Drawing B-Model No. GGTL80608.0 R1108A Exploded Drawing C-Model No. GGTL80608.0 R1108A Exploded Drawing D-Model No. GGTL80608.0 R1108A Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty