Gold's Gym GGTL80608.0 manual Troubleshooting, Problem The power turns off during use

Page 25
Reset
Position
cTripped Position

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 12). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 12. IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is inserted into the console. c. Check the reset/off circuit breaker located on the

treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five

minutes and then press the switch back in.

PROBLEM: The power turns off during use

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a

store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off

the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE

INFORMATION MODE on page 22 to turn off the demo mode.

 

PROBLEM: The displays of the console do not function properly

 

 

SOLUTION: a. Remove the key from the console and UNPLUG

a

74

THE POWER CORD. With the help of a second

person, carefully tip the Uprights (74, 78) down.

 

 

There may be two #8 x 2" Screws (105) in the bot-

 

 

tom of the Belly Pan (73). If there are, remove

 

 

them. Note: A Phillips screwdriver with a shaft at

78

73

least 5 in. (13 cm) long is required.

 

 

105

 

 

105

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Model No. GGTL80608.0 Serial No QUESTIONS?Table of Contents Pulse sensor is not a medical device Important PrecautionsVarious factors, including the users move Page Before YOU Begin Assembly Not to pinch the Upright Wire Make sure that the power cord is unpluggedDo not fully fold the Frame yet Nut the Wheel must turn freely. DiscardFully tighten the Bolts yet Be careful not to pinch the Upright WireSole MAY be Damaged When Power is Turned on Power is Turned onNot Connected PROPERLY, the CON Sole MAY be Damaged When Not Connected PROPERLY, the CONPull on the sleeve to make sure that it is Locked into place Not to pinch the wiresBe careful not to pinch the wires. Reattach HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerRun Measure your heart rate if desired Select a preset workout HOW to USE a Preset WorkoutPress the Start button to start the workout Select the Custom Workout Center HOW to USE the Custom Workout CenterPress the Start Workout button to start the workout Put on the chest pulse sensor HOW to USE the Fitness Test WorkoutSelect the fitness test workout Press the Start Fitness Test button to start the workoutConnector is fully plugged HOW to USE the Sound SystemInsert an iFit card and select a workout HOW to USE AN Ifit CardOptional Chest Pulse Sensor Information ModeHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingTop Problem The walking belt slows when walked onProblem Solution Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Key No. Qty Description Part LIST-Model No. GGTL80608.0105 #8 x 2 Screw Userʼs Manual 106 Right Handrail Trim Exploded Drawing A-Model No. GGTL80608.0 R1108A Exploded Drawing B-Model No. GGTL80608.0 R1108A Exploded Drawing C-Model No. GGTL80608.0 R1108A Exploded Drawing D-Model No. GGTL80608.0 R1108A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents