Gold's Gym GGTL80608.0 Make sure that the power cord is unplugged, Not to pinch the Upright Wire

1. Make sure that the power cord is unplugged.	1						B	A
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (56) so that the treadmill is more stable;							38 Hole	83
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)								81
and the shipping bracket (B).
Cut the shipping tie securing the Upright Wire								2
(38) to the Base (83). Locate a tie in the indi-
cated hole in the Base, and use the tie to pull
the Upright Wire out of the hole.
Attach a Base Pad (81) to the Base (83) in the				13
location shown with a #8 x 1" Tek Screw (2) and		56			81
a Base Pad Spacer (13). Then, attach another						2
Base Pad (81) with only a #8 x 1" Tek Screw (2).
2. Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),	2
and the shipping bracket (C) from the Base (83).
Attach a Wheel (84) with the Bolt and the Nut
that you just removed. Do not overtighten the
Nut; the Wheel must turn freely. Discard the					83
shipping bracket.			4
			C		84
				8
3. Identify the Right Upright (78) and the Right	3
Upright Spacer (79), which are marked with		38
stickers. Insert the Upright Wire (38) through the								78
Right Upright Spacer as shown. Set the Right
Upright Spacer on the Base (83). Be careful			Wire Tie					38
not to pinch the Upright Wire.							79
Have a second person hold the Right Upright								83
(78) near the Base (83). See the inset drawing.
Tie the wire tie in the Right Upright securely
around the end of the Upright Wire (38). With
the help of a second person, hold the Right
Upright near the Base. Then, pull the other end
of the wire tie until the Upright Wire is routed
completely through the Right Upright.	38			78
			Wire
	7			Tie