Gold's Gym GGTL80608.0 manual

Page 4

20. Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and switch the reset/off cir- cuit breaker to the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the circuit breaker.)

21. Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 6, and HOW TO FOLD AND MOVE THE TREADMILL on page 23.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

22. When folding or moving the treadmill, make sure that the storage latch is holding the frame securely in the storage position.

23. Never insert any object into any opening on the treadmill.

24. Inspect and properly tighten all parts of the treadmillDANGER:regularly.

25.Always unplug the power cord immediately after use, before cleaning the treadmill, and before performing the mainte- nance and adjustment procedures described in this manual. Never remove the motor hood un- less instructed to do so by an authorized ser- vice representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only.

26. This treadmill is intended for in-home use only. Do not use this treadmill in a commer- cial, rental, or institutional setting.

SAVE THESE INSTRUCTIONS

4

Image 4

Contents QUESTIONS? Model No. GGTL80608.0 Serial NoTable of Contents Pulse sensor is not a medical device Important PrecautionsVarious factors, including the users move Page Before YOU Begin Assembly Make sure that the power cord is unplugged Not to pinch the Upright WireDo not fully fold the Frame yet Nut the Wheel must turn freely. DiscardBe careful not to pinch the Upright Wire Fully tighten the Bolts yetPower is Turned on Sole MAY be Damaged When Power is Turned onNot Connected PROPERLY, the CON Sole MAY be Damaged When Not Connected PROPERLY, the CONNot to pinch the wires Pull on the sleeve to make sure that it is Locked into placeBe careful not to pinch the wires. Reattach HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeRun Measure your heart rate if desired Select a preset workout HOW to USE a Preset WorkoutPress the Start button to start the workout Select the Custom Workout Center HOW to USE the Custom Workout CenterPress the Start Workout button to start the workout HOW to USE the Fitness Test Workout Put on the chest pulse sensorSelect the fitness test workout Press the Start Fitness Test button to start the workoutHOW to USE the Sound System Connector is fully pluggedHOW to USE AN Ifit Card Insert an iFit card and select a workoutInformation Mode Optional Chest Pulse SensorHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on TopProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Part LIST-Model No. GGTL80608.0 Key No. Qty Description105 #8 x 2 Screw Userʼs Manual 106 Right Handrail Trim Exploded Drawing A-Model No. GGTL80608.0 R1108A Exploded Drawing B-Model No. GGTL80608.0 R1108A Exploded Drawing C-Model No. GGTL80608.0 R1108A Exploded Drawing D-Model No. GGTL80608.0 R1108A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT