5. Apply a small amount of grease to the axle on the Left | 5 |
|
|
Crank Arm (34). |
|
| |
|
|
| |
Identify the Left Pedal Leg (4), which is marked with |
| Grease | 34 |
an “L” sticker. Slide a Pedal Leg Spacer (73) and the |
| 73 |
|
Left Pedal Leg onto the axle on the Left Crank Arm |
| 4 |
|
(34). (Note: It may be helpful to use a rubber mallet to |
|
| |
|
|
| |
tap the Left Pedal Leg on. Do not to confuse the Left |
|
|
|
Pedal Leg with the Right Pedal Leg [not shown].) |
|
|
|
Attach the Left Pedal Leg with an M8 x 19mm Patch |
|
|
|
Screw (111), an M8 Washer (66), and a Torque |
|
|
|
Washer (106). |
|
|
|
Attach the Right Pedal Leg (not shown) in the same |
| 106 |
|
111 | 66 |
| |
way. |
| ||
|
|
| |
See the inset drawing. Identify the Left Pedal (10), |
|
|
|
which is marked with an “L” sticker. Attach the Left |
|
|
|
Pedal to the Left Pedal Leg (4) with two M6 x 48mm |
|
|
|
Flat Head Screws (83). Note: The Left Pedal can be |
|
|
|
attached in any of three positions using the three sets |
|
|
|
of holes in the Left Pedal Leg. |
| 83 |
|
|
|
| |
Attach the Right Pedal (not shown) to the Right |
|
|
|
Pedal Leg (not shown) in the same way. |
|
|
|
|
| 10 |
|
|
| 4 |
|
6. Hold a Pedal Wheel (28) inside of the bracket on one | 6 |
|
|
of the Upper Body Legs (31). Hold the Upper Body |
|
| |
|
|
| |
Leg and the Pedal Wheel inside of the bracket on the |
|
|
|
Left Pedal Leg (4). Slide a Pedal Leg Cover (33) onto |
|
|
|
the long side of an M8 x 63mm Bolt Set (65), and |
| 31 |
|
insert the Bolt Set into the Left Pedal Leg, the Upper |
|
|
|
Body Leg, and the Pedal Wheel. |
|
|
|
Slide a Pedal Leg Cover (33) onto the short side of the |
|
| 65 |
M8 x 63mm Bolt Set (65) and tighten it into the long |
|
| |
|
| 33 | |
side of the Bolt Set. |
|
| |
|
| 4 |
|
Attach the other Upper Body Leg (not shown) and |
| 33 |
|
the other Pedal Wheel (not shown) to the other |
|
| |
|
|
| |
side of the elliptical exerciser in the same way. |
|
|
|
|
| 65 |
|
|
| 28 |
|
7