
Important Note:
When operating on batteries, the power saver function minimizes battery drain, although a very small amount of current is still required by the tester. Turn the power switch off to completely disconnect the batteries.
2.5 Wall Mounting
The supplied
As shown in the figure below, the board is affixed to the wall with three screws (either M4 machine screws or 4.1 mm diameter wood screws). The Shoes and Wrist Strap Tester 747 is then attached to the board by align in the
Important Note:
Screws are not included. Please use either M4 machine screws or wood screws with a nominal diameter of 4.1 mm for mounting. Either flat head or round head screws may be used.
3.0 Testing
CAUTION
To reduce the risks associated with electrostatic discharge (ESD), which, if not avoided, may result in property damage to electronic components or assemblies being handled.
•Perform operational verification test to ensure proper operation of the 3M™ Shoes and Wrist Strap Tester 747 as required.
When used as a
With the SIGNAL OUT switch set to either of these positions, both ESD shoes and wrist tests can be performed.
12