3M 747 manual

Page 5

WARNING

Do not use power supply to power unit in Europe. Unit is intended to be powered by non-rechargeable battery and input connector is not to be used.

To reduce the risks associated with an explosion hazard, which, if not avoided, could result in death or serious injury:

•Do not use in an explosive environment. 3M™ Shoe and Wrist Strap Tester 747 is not designed to be intrinsically safe.

To reduce the risks associated with a medical device malfunction, which, if not avoided, could result in death or serious injury:

• Persons with heart pacemaker devices should never use this Shoes and Wrist Strap Tester 747.

CAUTION

To reduce the risks associated with hazardous voltage, which, if not avoided,, may result in minor or moderate injury and/or property damage:

•AC adapter must have all local required regulatory certifications.

•Do not use AC adapter and/or power cord if damaged.

•When replacing batteries, turn the power switch off and disconnect all the cables before beginning.

•Do not use in an outdoor and/or wet environment.

•Not intended to be serviced by the user. No user serviceable parts.

•Always replace battery cover before using the Shoes and Wrist Strap Tester 747.

To reduce the risks associated with electrostatic discharge (ESD), which, if not avoided, may result in property damage to electronic components or assemblies being handled:

•Perform operational verification test to ensure proper operation of the Shoes and Wrist Strap Tester 747 as required.

To reduce the risk associated with environmental contamination, which, if not avoided, may result in- contamination of land, water or air:

•Dispose of Shoes and Wrist Strap Tester 747 and/or batteries in accordance with governmental regulations at the end of product-life.

4

Page 4 Page 6
Image 5
Page 4 Page 6
Contents 3M Shoes and Wrist Strap Tester Table of Contents Inspection IntroductionIntended Use Explanation of Safety Label Signal Words & SymbolsPage Product Outline OverviewLCD Indicators Back Side Side PanelsConnecting the ESD Shoe Testing Plate Preparation Before TestingShoes Power Preparation Installing and Replacing the Batteries Turning Power Off Turning Power On and OffPower Saver Function AC Adapter ConnectionWall Mounting TestingESD Shoe Testing with the 3M Shoes and Wrist Strap Tester ALL setting is described in .1, Open Collector OutputImportant Note Use single-conductor wrist straps only Open Collector Output External Output FunctionInternal Circuit Test Result Output SettingsTest Result Output Terminal Open-Collector Output Shoe and Wrist Strap ALL SettingRS-232C Communications SpecificationsPC System Requirements PC ConnectionCable Connections Measurement Resistance Range 0 to 200.0 MΩ Measurement SectionBattery Replacement Indicator Maintenance & ServiceLCD can display the following error messages Error MessagesOperational Verification Test CleaningTesting Considerations Test Set-Up Testing Wrist Strap RangesEquipment Required Wrist Test Table Testing Wrist Low Limit Refer to Wrist Test TableTesting Wrist High Limits Refer to Wrist Test Table Testing Shoes Low Limits Refer to Shoes Test Table Testing Shoe RangesShoe Test Table Regulatory InformationWeee Statement CULus StatementFCC Electronic Solutions Division Static Control Products
Related manuals
Manual 40 pages 58.99 Kb
Top Page Image Contents