3M 747 manual Fcc

Page 29

FCC

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help. Restriction of the use of certain hazardous substances (RoHS): Meets 2011- 65-EU Directive.

To reduce the risks associated with environmental contamination from the device along with the Lithium and Akaline battery:

•At the end of service life, dispose of the charge analyzer and batteries in ac- cordance with federal, state and local requirements.

Per the European Battery Directive, Alkaline Batteries are not provided with the equipment and must be locally sourced

28

Page 28 Page 30
Image 29
Page 28 Page 30
Contents 3M Shoes and Wrist Strap Tester Table of Contents Inspection IntroductionIntended Use Explanation of Safety Label Signal Words & SymbolsPage Product Outline OverviewLCD Indicators Back Side Side PanelsConnecting the ESD Shoe Testing Plate Preparation Before TestingShoes Power Preparation Installing and Replacing the Batteries Turning Power Off Turning Power On and OffPower Saver Function AC Adapter ConnectionWall Mounting TestingESD Shoe Testing with the 3M Shoes and Wrist Strap Tester ALL setting is described in .1, Open Collector OutputImportant Note Use single-conductor wrist straps only Open Collector Output External Output FunctionInternal Circuit Test Result Output SettingsTest Result Output Terminal Open-Collector Output Shoe and Wrist Strap ALL SettingRS-232C Communications SpecificationsPC System Requirements PC ConnectionCable Connections Measurement Resistance Range 0 to 200.0 MΩ Measurement SectionBattery Replacement Indicator Maintenance & ServiceLCD can display the following error messages Error MessagesOperational Verification Test CleaningTesting Considerations Test Set-Up Testing Wrist Strap RangesEquipment Required Wrist Test Table Testing Wrist Low Limit Refer to Wrist Test TableTesting Wrist High Limits Refer to Wrist Test Table Testing Shoes Low Limits Refer to Shoes Test Table Testing Shoe RangesShoe Test Table Regulatory InformationWeee Statement CULus StatementFCC Electronic Solutions Division Static Control Products
Related manuals
Manual 40 pages 58.99 Kb
Top Page Image Contents