•Combination Lap/Shoulder Belt with Sliding Latch Plate
This belt has a latchplate that slides freely along the belt.
This belt MUST be converted to prevent movement of the lap portion of the belt. You must use the locking clip provided with the
infant restraint, unless your vehicle's seat belt Locking clip can be converted in another way as described
in your vehicle owner's manual.
To Install Locking Clip:
1.Tighten the buckled belt by pushing down hard on the infant restraint and pulling hard on the shoulder belt.
2.While pushing down on infant restraint, pinch the two straps together behind the buckle tongue. Unbuckle the belt without allowing it to slip.
½
inch
3.Connect lap and shoulder belts with locking clip as shown and .
4.Rebuckle belt. Check that lap belt does not move by pulling and pushing hard on infant restraint. If belt loosens or lengthens, repeat procedure.
Locking clip goes here,
1/2 inch from the buckle
23