Spalding M881119, M881117, M881115, M881111 manual Use wedge to tap cap of ground sleeve until tight

Page 31

1. After concrete has cured, remove tape, install pole cap (26), fit pole assembly into sleeve (4).

WARNING!

TWO PEOPLE REQUIRED

FOR THIS PROCEDURE.

FAILURE TO FOLLOW THIS

WARNING COULD RESULT IN

SERIOUS INJURY AND/OR

PROPERTY DAMAGE.

WARNING!

DO NOT USE THE BACKBOARD OR RIM TO MOVE POLE ASSEMBLY INTO POSITION. THE BACKBOARD AND RIM ARE NOT LOCKED AND WILL ROTATE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.

26

4

2.

Use wedge to tap cap of ground sleeve until tight.

5

31

12/05

ID# M881111

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Required Tools and Materials Before YOU Start ID# 588000 05/05 Safety Instructions Warranty Card Parts List See Hardware Identifier Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole Middle Bottom Fill hole approximately 1/3 full with mixed concrete FIG. a IDE VIE W Keep Ground Sleeve Keep Ground Sleeve Middle Pole Front Side Tighten just until Side Section B Assemble the Elevator Tubes to Backboard Do not Tighten ID# M881111 12/05 27, and nut 24 as shown Container to Mix 12/05 ID# M881111 Install Slam Jam Rim to Backboard USE EYE Reinforcement Bar Install net Tools Required for this Section Use wedge to tap cap of ground sleeve until tight Do not Allow Children To Adjust Height
Top Page Image Contents