Spalding M881119, M881117, M881115, M881111, M881113 manual Required Tools and Materials

Page 1

Inground System Owners Manual

Customer Service Center

•N53 W24700 South Corporate Circle • Sussex, WI 53089

•U.S.A.

REQUIRED TOOLS AND MATERIALS:

• 2 People

• Carpenter’s Level

• 15’ Tape Measure

•Shovel & Post Hole Digger

• Wood Board (scrap)

• Tape

•Sawhorse or Support Table

• Wedge

• Phillips Screwdriver

• Hammer

• Heavy Duty Tape

• Stepladder 8 ft. (2.4 m)

• Safety Goggles

•(2 each) Wrenches and/or Socket Wrenches and Sockets (Deep-Well Sockets are Recommended).

7/16" 1/2" 9/16" 3/4"

• Optional: Large &

Small Adjustable

Wrenches

7/16" 1/2" 9/16" 3/4"

•

• Container to Mix

WARNING!

READ AND UNDERSTAND OPERATOR'S MANUAL BEFORE USING THIS UNIT.

FAILURE TO FOLLOW OPERATING INSTRUCTIONS COULD RESULT IN INJURY OR DAMAGE TO PROPERTY.

Toll-Free Customer Service Number for U.S: 1-800-558-5234,

For Canada: 1-800-284-8339,

For Europe: 00 800 555 85234 (Sweden: 009 555 85234),

For Australia: 1-800-632 792

Internet Address: http://www.huffysports.com

1

12/05

ID# M881111

© COPYRIGHT 2005 SPALDING

Page 1 Page 2
Image 1
Page 1 Page 2
Contents Required Tools and Materials Before YOU Start ID# 588000 05/05 Safety Instructions Warranty Card Parts List See Hardware Identifier Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole Middle Bottom Fill hole approximately 1/3 full with mixed concrete FIG. a IDE VIE W Keep Ground Sleeve Keep Ground Sleeve Middle Pole Front Side Tighten just until Side Section B Assemble the Elevator Tubes to Backboard Do not Tighten ID# M881111 12/05 27, and nut 24 as shown Container to Mix 12/05 ID# M881111 Install Slam Jam Rim to Backboard USE EYE Reinforcement Bar Install net Tools Required for this Section Use wedge to tap cap of ground sleeve until tight Do not Allow Children To Adjust Height
Top Page Image Contents