Spalding M881117, M881119, M881115, M881111, M881113 manual Keep Ground Sleeve

Page 15

9. Stack and bounce bottom (3) and middle (2) pole sections together. Bounce pole sections together until middle section no longer moves toward taped reference mark on bottom pole.

IMPORTANT!

5"

(12.7 cm)

BOTTOM POLE

1-1/2"

(3.81 cm)

POLE SECTIONS SHOULD HAVE A 3-1/2" (9 CM)

MINIMUM

OVERLAP.

2

BOTTOM POLE

Identification Sticker

IMPORTANT!

KEEP GROUND SLEEVE

CAP ON BOTTOM POLE.

5

3

Wood Scrap (NOT SUPPLIED)

15

12/05

ID# M881111

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Required Tools and Materials Before YOU Start ID# 588000 05/05 Safety Instructions Warranty Card Parts List See Hardware Identifier Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole Middle Bottom Fill hole approximately 1/3 full with mixed concrete FIG. a IDE VIE W Keep Ground Sleeve Keep Ground Sleeve Middle Pole Front Side Tighten just until Side Section B Assemble the Elevator Tubes to Backboard Do not Tighten ID# M881111 12/05 27, and nut 24 as shown Container to Mix 12/05 ID# M881111 Install Slam Jam Rim to Backboard USE EYE Reinforcement Bar Install net Tools Required for this Section Use wedge to tap cap of ground sleeve until tight Do not Allow Children To Adjust Height
Top Page Image Contents