Spalding M881117, M881119, M881115, M881111, M881113 manual Warranty Card

Page 5

NOTICE TO ASSEMBLERS

ALL Basketball Systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand, water or concrete according to the instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.

IMPORTANT!

Remove all contents from boxes.

Be sure to check inside pole sections; hardware and additional parts are packed inside.

WARRANTY CARD:

Please remember to complete your product registration form either on-line at: www.huffysports.com/customer_support/product_registration or mail-in the enclosed postcard.

For more information on assembly, placement, proper use, and maintenance, visit The American Basketball Council website at http://www.smarthoops.com.

5

12/05

ID# M881111

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Required Tools and Materials Before YOU Start ID# 588000 05/05 Safety Instructions Warranty Card Parts List See Hardware Identifier Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole Middle Bottom Fill hole approximately 1/3 full with mixed concrete FIG. a IDE VIE W Keep Ground Sleeve Keep Ground Sleeve Middle Pole Front Side Tighten just until Side Section B Assemble the Elevator Tubes to Backboard Do not Tighten ID# M881111 12/05 27, and nut 24 as shown Container to Mix 12/05 ID# M881111 Install Slam Jam Rim to Backboard USE EYE Reinforcement Bar Install net Tools Required for this Section Use wedge to tap cap of ground sleeve until tight Do not Allow Children To Adjust Height
Top Page Image Contents