Spalding M881111, M881117, M881119, M881115, M881113 manual Reinforcement Bar

Page 28

6.

49

49

Assemble rebar centering spacers

(49)near top and bottom of rebar

(48)as shown.

2"

48

49

48

3"

7. Place rebar with spacers into bottom pole section (3) as shown.

3

Reinforcement Bar

8. Seal hole at the bottom of the bottom pole with heavy-duty tape (not included) to retain rebar and concrete inside.

48

Tape (Not Included)

ID# M881111 12/05

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Required Tools and Materials Before YOU Start ID# 588000 05/05 Safety Instructions Warranty Card Parts List See Hardware Identifier Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole Middle Bottom Fill hole approximately 1/3 full with mixed concrete FIG. a IDE VIE W Keep Ground Sleeve Keep Ground Sleeve Middle Pole Front Side Tighten just until Side Section B Assemble the Elevator Tubes to Backboard Do not Tighten ID# M881111 12/05 27, and nut 24 as shown Container to Mix 12/05 ID# M881111 Install Slam Jam Rim to Backboard USE EYE Reinforcement Bar Install net Tools Required for this Section Use wedge to tap cap of ground sleeve until tight Do not Allow Children To Adjust Height
Top Page Image Contents