Spalding M881115, M881117, M881119, M881111, M881113 manual Before YOU Start

Page 2

BEFORE YOU START!

To ensure optimal playability of backboard system, a close tolerance fit between the elevator components and hardware is required. Test-fit large bolts into large holes of elevator tubes, backboard brackets, and triangle plates. Carefully rock them in a circular motion to ream out any excess paint from holes if necessary.

Not all items pictured are included with every model.

ID# M881111 12/05

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Required Tools and Materials Before YOU Start ID# 588000 05/05 Safety Instructions Warranty Card Parts List See Hardware Identifier Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole Middle Bottom Fill hole approximately 1/3 full with mixed concrete FIG. a IDE VIE W Keep Ground Sleeve Keep Ground Sleeve Middle Pole Front Side Tighten just until Side Section B Assemble the Elevator Tubes to Backboard Do not Tighten ID# M881111 12/05 27, and nut 24 as shown Container to Mix 12/05 ID# M881111 Install Slam Jam Rim to Backboard USE EYE Reinforcement Bar Install net Tools Required for this Section Use wedge to tap cap of ground sleeve until tight Do not Allow Children To Adjust Height
Top Page Image Contents