Spalding M881113, M881117, M881119, M881115, M881111 manual Keep Ground Sleeve

Page 14

8.After concrete has cured, remove bottom pole section from ground sleeve (4). Place anti- skid tape (36) around the bottom area of bottom pole (see note A).

36

5

4

NOTE A:

Place top edge of anti- skid tape on mark made in step 7, NOTE A.

NOTE B:

Tape prevents the pole from rotating during play.

IMPORTANT!

KEEP GROUND SLEEVE

CAP ON BOTTOM POLE.

ID# M881111 12/05

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Required Tools and Materials Before YOU Start ID# 588000 05/05 Safety Instructions Warranty Card Parts List See Hardware Identifier Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole Middle Bottom Fill hole approximately 1/3 full with mixed concrete FIG. a IDE VIE W Keep Ground Sleeve Keep Ground Sleeve Middle Pole Front Side Tighten just until Side Section B Assemble the Elevator Tubes to Backboard Do not Tighten ID# M881111 12/05 27, and nut 24 as shown Container to Mix 12/05 ID# M881111 Install Slam Jam Rim to Backboard USE EYE Reinforcement Bar Install net Tools Required for this Section Use wedge to tap cap of ground sleeve until tight Do not Allow Children To Adjust Height
Top Page Image Contents