JVC RX-9000VBK manual Insert the RF rod antenna to the RF Remote Antenna terminal

Setting Up the RF Rod Antenna Setting Up the IR Signal Transmitter

The RF rod antenna is supplied with this receiver to allow you to use the Multi-room function.

With the RF rod antenna, you can operate the receiver at a distance of up to 50 feet (15 m) using the remote control. However, If the antenna cannot receive signals stably, you cannot operate the receiver correctly.

•The signal-reachable distance may differ depending on the operating conditions and circumstances.

The remote control supplied with this receiver can transmit both RF (Radio Frequency) signal and IR (infrared) signal at the same time to operate the receiver.

The RF rod antenna can receive the RF signals emitted from the remote control. This means that you do not have to aim the remote control at the remote sensor on the receiver when operating the receiver.

•Without the RF rod antenna connected, you can operate the receiver with the remote control, aiming the remote control directly toward the remote sensor on the receiver.

To set up the RF rod antenna

1.Insert the RF rod antenna to the RF REMOTE ANTENNA terminal.

RF

REMOTE

ANTENNA

IR

OUT

The IR signal transmitter can transmit the IR signals.

It allows you to use the AV COMPULINK system, and to operate other manufacturers’ video components. Without the IR transmitter connected, you can operate other components with the remote control, aiming the remote control directly toward the remote sensor on the target components. However, the IR signal transmitter reduces the possibility of malfunction.

•The IR signal transmitter may not operate the target components depending on the operating conditions and circumstances — including the aiming angle and direction of the IR signal transmitter toward the remote sensors of the target components. If this occurs, changing its aiming angle and direction toward the remote sensors may solve the problem.

To set up the IR signal transmitter

1.Find the place where you attach the IR signal transmitter.

•Place it where the signal can reach the remote sensor of the target components directly (in the line-of-sight).

•If the cord length of the IR signal transmitter is not long enough, use an extension cord (separately purchased).

2.Attach the double-sided adhesive tape (supplied) to the IR signal transmitter.

IR signal transmitter

2.Rotate the fixing nut to attach the RF rod antenna firmly.

RF

REMOTE

ANTENNA

IR

OUT

Double-sided adhesive tape

3.Connect the plug of the transmitter to the IR OUT jack of the receiver and place the

transmitter.

RF REMOTE

ANTENNA

IR OUT

Less	than
(3			10
	m	)		feet

At an angle of

approx. 60°

Signal-emitting angle of the transmitter

Horizontally: 60˚	Vertically: 60˚
	15°
	45°
30°
30°

10