JVC RX-9000VBK Compu Link Remote Control System, CD player CD recorder Cassette deck MD recorder

COMPU LINK Remote Control System

The COMPU LINK remote control system allows you to operate JVC audio components through this receiver.

To use this remote control system, you need to connect JVC audio components through the COMPU LINK jacks (see below) in addition to the connections using cables with RCA pin plugs (see pages 6 and 7).

•Make sure that the AC power cords of these components are unplugged before connection. Plug the AC power cords only after all connections are complete.

CD player

CD recorder

Cassette deck

or

MD recorder

COMPU LINK – 4

(SYNCHRO)

Turntable

Notes:

•There are four versions of COMPU LINK remote control system. This receiver is equipped with the fourth version — COMPU LINK- 4. This version is created by adding systematic operations with the CD recorder to the previous version — COMPU LINK-3.

•If your audio component has two COMPU LINK jacks, you can use either one. If it has only one COMPU LINK jack, connect it so that it is the last item in the series of components. (For example, the turntable or CD player in the diagram above.)

•To operate the cassette deck or MD recorder using the COMPU LINK remote control system, set the source name correctly. (See page 23.)

•Refer also to the manuals supplied with your audio components.

This remote control system allows you to use four functions listed below.

Remote Control through the Remote Sensor on the Receiver

You can control the connected audio components through the receiver using this remote control. For details, see pages 57 and 58.

Automatic Source Selection

•When you press the play (3) button on a connected component or on its own remote control, the receiver automatically turns on and changes the main room source to the component.

–If the receiver is already turned on and the SUB ROOM CONTROL lamp on the front panel is lit green, the receiver changes the sub-room source to the component.

•When you press PLAY on the remote control supplied with this receiver, the receiver automatically turns on and changes the main room source or sub-room source (depending on the multi-room operation selector setting on the remote control) to the target component.

•When you select a new source on the receiver or on the remote control supplied with this receiver either for the main room or sub-room, the newly selected component begins playing immediately, and the previously selected source continues playing without sound for a few seconds.

Automatic Power On/Off (Standby): only possible with the COMPU LINK-3 and COMPU LINK--4 connection

Automatic Power On:

•When you turn on the receiver by pressing POWER on the front panel or AUDIO POWER ON on the remote control (with the multi-room operation selector set to “MAIN ROOM”):

OR

When you turn on the main room sound by pressing MAIN ROOM ON/OFF while the receiver is turned on:

\The MAIN ROOM ON/OFF lamp on the front panel lights red, and one of the connected components will turn on automatically, depending on which component has been previously selected as the main room source.

•When you turn on the receiver by pressing AUDIO POWER ON on the remote control (with the multi-room operation selector set to “SUB ROOM”):

OR

When you turn on the sub-room sound by pressing SUB ROOM ON/OFF while the receiver is turned on:

\The SUB ROOM ON/OFF lamp on the front panel lights green, and one of the connected components will turn on automatically, depending on which component has been previously selected as the sub-room source.

Continued to the next page.

47