JVC RX-9000VBK Muting the Main Room Sound, Reinforcing the Bass, Attenuating the Input Signal

Muting the Main Room Sound

From the remote control ONLY:

Press MUTING to mute the sound through all MUTING

speakers in the main room and headphones connected.

“MUTING” appears on the display and the volume turns off (the volume level indicator goes off).

To restore the sound, press MUTING again so that “OFF” appears on the display.

•Turning MASTER VOLUME on the front panel or pressing VOLUME +/– on the remote control also restores the sound.

Reinforcing the Bass

Human ears are not sensitive to bass at low volume. To compensate for this, the bass boost function automatically boost the bass level as you lower the volume.

	BASS BOOST
On the front panel ONLY:
Press BASS BOOST (SOURCE NAME)	SOURCENAME
briefly to select the bass boost function.

•Each time you press the button, the bass boost function turns on (“BASSBOOST ON”) and off (“BASSBOOST OFF”).

–Select “BASSBOOST ON” to activate the bass boost function. The BASS BOOST indicator lights up on the display.

–Select “BASSBOOST OFF” to cancel it.

The indicator goes off.

Note:

This function affects the front speaker sounds in the main room only.

Attenuating the Input Signal

When the input level of the playing source is too high, the sounds will be distorted. If this happens, you need to attenuate the input signal level to prevent the sound distortion.

Adjusting the Subwoofer Output Level

You can adjust the subwoofer output level if you have selected “YES” for the “SUBWOOFER” (see page 23).

Once it has been adjusted, the receiver memorizes the adjustment.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•When the front speakers are all deactivated, the subwoofer level cannot be adjusted.

On the front panel:

1. Press BALANCE/SURROUND	BALANCE/SURROUND
	ADJUST
ADJUST repeatedly until
“SUBWFR LEVEL” appears on
the display.

The display changes to show the current setting.

2.	Turn MULTI JOG to adjust the	MULTI JOG
	subwoofer output level (–10 dB to
	+10 dB).
From the remote control:		SOUND
1.	Press SOUND.
	The 10 keys are activated for sound adjustments.
2.	Press SUBWOOFER –/+ to adjust	SUBWOOFER
	the subwoofer output level (–10 dB
		0	+10
	to +10 dB).	FM MODE	100+

Note:

This function is applied only to the main room sources.

On the front panel ONLY:

Press and hold INPUT ATT. (SOUND SELECT) so that the INPUT ATT indicator lights up on the display.

•Each time you press and hold the button, the Input Attenuator mode turns on (“INPUT ATT ON”) or off (“INPUT NORMAL”).

Notes:

SOUND SELECT

INPUT ATT.

•This effect is applied to only the main room sources connected using the analog terminals (except “DVD MULTI”).

•This function takes effect when the DSP mode is in use.

18