JVC RX-9000VBK manual Connecting Audio/Video Components, Connecting the rear and center speakers

Page 8

Connecting the rear and center speakers

Connect rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals.

Center

speaker

CENTER

REAR

CAUTION: SPEAKER IMPEDANCE

SPEAKER

SPEAKERS

8 ~ 16

+

 

+

Right rear

 

Left rear

speaker

 

speaker

–

 

–

 

RIGHT

LEFT

Connecting the subwoofer speaker

You can enhance the bass by connecting a subwoofer. Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied).

SUBWOOFER

OUT

Powered subwoofer

Connecting Audio/Video Components

You can connect the following audio/video components to this receiver. Refer also to the manuals supplied with your components.

Audio Components

Video Components

• Turntable

• DVD player*

 

 

• CD player*

• TV*

 

 

• Cassette deck

• DBS tuner*

or MD recorder*

• VCR(s)

 

 

• CD recorder*

• Video camera

 

 

*You can connect these components using the methods described in “Analog connections” (to the right) or in “Digital connections” (see page 9).

Analog connections

Audio component connections

Use the cables with RCA pin plugs (not supplied).

Connect the white plug to the audio left jack, and the red plug to the audio right jack.

CAUTION:

If you connect a sound-enhancing device such as a graphic equalizer between the source components and this receiver, the sound output through this receiver may be distorted.

Turntable

If an earth cable is provided for your turntable, connect the cable to the screw marked (H) on the rear panel.

RIGHT

LEFT AUDIO

Turntable

PHONO

 

CD

 

OUT

 

(REC)

 

TAPE

To audio output

/MD

IN

 

(PLAY)

Note:

Any turntables incorporating a small-output cartridge such as an MC (moving-coil) type must be connected to this receiver through a commercial head amplifier or step-up transformer. Direct connection may result in insufficient volume.

CD player

RIGHT LEFT AUDIO

 

PHONO

CD player

 

 

CD

 

OUT

To audio output

(REC)

TAPE

 

/MD

 

IN

 

(PLAY)

6

Page 7 Page 9
Image 8
Page 7 Page 9
Contents RX-9000VBK For the main unit Table of Contents Introduction FeaturesPrecautions Remote Control Front Panel Parts IdentificationBefore Installation Checking the Supplied AccessoriesConnecting the FM and AM Antennas Getting StartedConnecting the Speakers Basic connecting procedureConnecting the front speakers AM Antenna ConnectionsConnecting Audio/Video Components Connecting the rear and center speakersConnecting the subwoofer speaker Analog connectionsVideo component connections Cassette deck or MD recorderCD recorder DVD player Video cameraTV and/or DBS tuner Digital connections Digital input terminalsDBS tuner DVD player Digital output terminalFind the place where you attach the IR signal transmitter To set up the RF rod antennaTo set up the IR signal transmitter Insert the RF rod antenna to the RF Remote Antenna terminalPutting Batteries in the Remote Control Connecting the Power CordPlug the power cord into an AC outlet Replace the coverMulti-room Operations Required Speaker Connections for the Sub-roomConnection  Connection ı MeritsBasic Operating Procedure for Main Room Press PowerPress Audio Power on Select and play a sourceBasic Operating Procedure for Sub-Room GreenSub-room Set the multi-room operation selector to SUB RoomMain Room Basic Operations Turning the Power On and Off StandbyCanceling the Main Room Operations Signal and speaker indicators on the display When digital input is selected Lights up when the leftWhen analog input is selected Always lights up Selecting the Main Room Source to PlayAdjusting the Main Room Volume Activating the Main Room Front SpeakersEtc Selecting different sources for picture and soundAttenuating the Input Signal Adjusting the Subwoofer Output LevelMuting the Main Room Sound Reinforcing the BassAdjusting the Front Speaker Output Balance Using the Sleep TimerChanging the Display Brightness Recording a SourceSub-Room Operations Press SUB Room ControlPress SUB Room ON/OFF For the sub-room operationsCanceling the Sub-room Operations Selecting the Sub-room Source to PlayTo use this receiver for the sub-room operations again Selected source name for sub-room appearsAdjusting the Sub-room Volume Muting the Sub-room Sound Operating the Playback Source for Sub-roomActivating the Sub-room Front Speakers Press Muting to mute the sound throughBasic Settings Setting the Front Speakers Either for Main Room or Sub-roomSetting the Subwoofer Information Changing the Source NameRear Delay appears on Display Setting the Speakers for the DSP ModesPress Setting repeatedly until Delay time of the rear speaker Turn Multi JOG to selectOutput Frequency appears on the displayDigital Input Digital in Terminal Setting SettingsSelecting the Analog or Digital Input Mode OPT. DIG. in appears on DisplayShowing the Text Information on Display Storing the Basic Settings Adjustments One Touch Operation Adjust the sound using the functions listed abovePress ONE Touch OPERATION. Onetouchoperation MemoUsing Preset Tuning Tuning in Stations ManuallyReceiving Radio Broadcasts Press TUNER/SEA MemoryAssigning Names to Preset Stations Selecting the FM Reception ModeCreating Your Own SEA Mode Using the SEA ModesSelecting Your Favorite SEA Mode Surround modes Using the DSP ModesWhat are the DSP Modes? DVD Multi Playback Mode Reproducing the Sound FieldDAP modes 3D-PHONIC modesBy pressing DSP Mode By pressing Surround Mode Available DSP Modes According to the Speaker ArrangementSpeaker arrangements Available DSP modes To activate the SurroundAdjusting the Surround Modes Adjust the rear tone Adjust the center toneTheater appears on Display Adjust the speaker output levels Large Theater or DIG LAdjust the room size sense Adjust the livenessAdjust the overall level of the effects Press Surround ModeAdjusting the DAP Modes Press DSP Mode repeatedly untilDAP mode Live Club HALL, or Concert Arena Appears on the displayRepeatedly until the DAP mode Concert HALL, or Concert Arena appears on the displaySelect and play a sound source Mode you want appears on DisplayActivating the DSP Modes Using the DVD Multi Playback Mode Activating the DVD Multi Playback ModePress DVD Multi so that DVD Multi appears on the displayUsing the On-Screen Menus When you finish, press ExitPress Menu Press %/ Þto move to VisualPress %/ Þto move to Sound CONTROL, then press @/ # Press %/ Þto moveAdjusting the DVD Multi Playback Mode Press %/ Þto move To Surround LEVEL, then press @/ #For Dolby Pro Logic For Dolby Digital and DTS Digital SurroundPress %/ Þ/ @/ #to adjust the SEA mode as you want Press SET to store the setting into the SEAPress %/ Þto move To SETTING, then press @/ # Press %/ Þto move to SEA, then press @ / #Press %/ Þto move To Preset Name Then press SET Press %/ Þto move To Preset MEMORY, then press @/ #Preset station number Press %/ Þto move to Tuner CONTROL, then press @/ #Compu Link Remote Control System Remote Control through the Remote Sensor on the ReceiverCD player CD recorder Cassette deck MD recorder Automatic Source SelectionSame time Synchronized RecordingText Compu Link Remote Control System CD player MD recorderDisplaying the Disc Information on the TV screen Disc Search Only for CD PlayerPress Text Display while CD or MD is selected as the source Disc Information screenShowing the Disc Information on the TV Screen To exit from the Disc information screenPress Text Display while CD is selected as the source Press %/ Þto move To SEARCH, then Press SETPress %/ Þto move To Performer Then press SET Press SET againPress %/ Þto move to Search Then press SET Press %/ Þto move To GENRE, then Press SETPress %/ Þto move To Title INPUT, then press SET Entering the Disc InformationPress %/ Þto move to the genre you want, then press SET Press Text Display while MD is selected as the sourcePress %/ Þto move to Title Input Then press SET For the MD recorderAV Compu Link Remote Control System Target video componentsIf the AV Compu Link terminal on the TV is RECEIVER/AMP If the AV Compu Link terminal on the TV is AV Compu Link EXOne-Touch Video Play CASE1 If the components are equipped with the S-videoTerminals Video terminals One-Touch DVD Play Automatic Power On/Off StandbyAutomatic Power On Operating JVC’s Audio/Video Components TunerSound control section Amplifier CD playerCD player-changer CD recorderTurntable Cassette deckVCR 1 VCR connected to VCR 1 jacks DVD playerMulti only for the main room Operations, these buttons can beRelease TV/CATV/DBS Power Set the remote control mode to CATV/DBSIf there are more than one code listed for your brand of TV Operating Other Manufacturers’ Video EquipmentIf there are more than one code listed for your brand Try to operate your VCR by pressing VCR 1 PowerRelease VCR 1 Power 28, 29, 60 11, 44Echostar Expressvu General Instrument Hitachi Panasonic PrimestarTroubleshooting Problem Possible Cause SolutionConnect an Ntsc TV Specifications AmplifierFM tuner IHF AM tuner1099 781 954 650Valley Road Wayne, NJ Limited Warranty AUDIO-2 0200HIMMDWJEIN

RX-9000VBK specifications

The JVC RX-9000VBK is a powerful and versatile A/V receiver designed to cater to the needs of audiophiles and home theater enthusiasts alike. With a sleek, modern design, this receiver combines advanced technology with user-friendly features to deliver an exceptional audio and visual experience.

One of the standout features of the RX-9000VBK is its impressive power output. With a total of 100 watts per channel, this receiver can drive even large speakers with ease, ensuring that you enjoy your favorite movies, music, and games with robust sound. The built-in 7.1 channel surround sound capability creates an immersive audio experience, making you feel like you are part of the action.

The RX-9000VBK is equipped with JVC's proprietary HD Codec, which enhances the audio quality by providing high-definition sound processing. This technology ensures that audio tracks are reproduced accurately, capturing the nuances of every detail. The receiver also supports a variety of audio formats, including Dolby Digital and DTS, allowing you to enjoy your media in the best possible quality.

In addition to its impressive audio capabilities, the JVC RX-9000VBK offers a range of connectivity options. It features multiple HDMI inputs, enabling you to connect various devices such as Blu-ray players, gaming consoles, and streaming devices. The integrated HDMI ARC (Audio Return Channel) allows for easy connection to your TV, simplifying the overall setup.

The user interface of the RX-9000VBK is designed with convenience in mind. It includes an intuitive on-screen display that makes navigation simple, whether you’re adjusting audio settings or selecting input sources. The receiver also comes with a remote control, providing you with the flexibility to operate your home theater system from anywhere in the room.

Additionally, the JVC RX-9000VBK includes a built-in FM tuner, allowing you to enjoy your favorite radio stations with crystal-clear sound quality. The receiver is also compatible with external audio sources, including USB drives and musical instruments, making it a great choice for musicians and music lovers.

Overall, the JVC RX-9000VBK stands out for its robust power, advanced audio technologies, and thoughtful design. It is an excellent choice for anyone looking to enhance their home audio experience, providing both performance and versatility in a single package. Whether you are hosting movie nights, gaming sessions, or simply enjoying your favorite playlists, the RX-9000VBK is sure to deliver exceptional sound quality and performance.
Top Page Image Contents