ProForm PFTL57908.0 Make sure that the power cord is unplugged, Do not fully fold the Frame yet

1. Make sure that the power cord is unplugged.	1				Hole
With the help of a second person, carefully tip			91		97
the treadmill onto its left side. Partially fold the
Frame (48) so that the treadmill is more stable;							6
do not fully fold the Frame yet.					96
Cut the shipping tie securing the Wire Harness
(91) to the Base (96). Locate the plastic tie in
the indicated hole in the Base, and use the tie to
pull the Wire Harness out of the hole.	48	98 97 6
Attach two Base Feet (97) to the Base (96) in the
locations shown with two Base Foot Spacers
(98) and two #8 x 1" Tek Screws (6).						97
Then, attach the other two Base Feet (97) with
							6
two #8 x 1" Tek Screws (6).
		98	97
2. See the inset drawing. Cut the plastic tie near	2	Plastic Tie
the Wire Harness (91).
Attach a Wheel (99) with a 3/8" x 2" Bolt (9) and
a 3/8" Nut (10) to the Base (96). Do not over-
tighten the Nut; the Wheel must turn freely.	9
		1099	96		Cut
					91
3. Identify the Right Upright (92) and the Right	3
Upright Spacer (100), which are marked with
stickers. Insert the Wire Harness (91) through					92
the Right Upright Spacer as shown. Set the
Right Upright Spacer on the Base (96).	91
With the help of a second person, hold the Right						91
	Wire Tie
Upright (92) near the Base (96). See the inset				100
drawing. Tie the wire tie in the Right Upright se-
curely around the end of the Wire Harness (91).							96
Then, pull the other end of the wire tie until the
Wire Harness is routed completely through the
Right Upright.		92
	91	Wire
		Tie
	7