ProForm PFTL14511.1 user manual Top View, Symptom The walking belt slows when walked on

Page 30

Locate the Reed Switch (52) and the Magnet (50) on the left side of the Pulley (49). Turn the Pulley until the Magnet is aligned with the Reed Switch.

Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If necessary, loosen the #8 x 3/4" Tek Screw (14), move the Reed Switch slightly, and then retighten the Screw. Reattach the Motor Hood (not shown) and run the treadmill for a few minutes to check for a correct speed reading.

When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.

b

2–3 in.

Top

View

52

14

1/8 in.

49

50

Idler Roller Screws

SYMPTOM: The incline of the treadmill does not change correctly

a.Calibrate the incline system (see step 4 on page 25).

SYMPTOM: The walking belt slows when walked on

a.Use only a surge suppressor that meets all of the specifications described on page 15.

b.If the walking belt is overtightened, treadmill per- formance may decrease and the walking belt may become damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn.

c.Your treadmill features a walking belt coated with high-performance lubricant. IMPORTANT: Never apply silicone spray or other substances to the walking belt or the walking platform unless instructed to do so by an authorized service representative. Such substances may deterio- rate the walking belt and cause excessive wear. If you suspect that the walking belt needs more lubricant, see the front cover of this manual.

d.If the walking belt still slows when walked on, see the front cover of this manual.

30

Image 30

Contents Call TOLL-FREE QUESTIONS?Model No. PFTL14511.1 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Before YOU Begin Part Identification Chart Assembly Make sure that the power cord is unpluggedTighten the Screws yet. Note It may be help See the inset drawing. Tie the wire tieBe careful not to pinch the Upright Wire Attach the Right Upright not shownBase Covers into place yet Page Again. if YOU do not Connect the CON Wire. See the inset drawing. The connectorsShould slide together easily and snap into Then tighten themPage When the frame stops moving, remove Power cord. Next, see page 17 and turn onPower Important See page 15 and plugPage Operation and Adjustment HOW to Connect the Power CordUse a Surge Suppressor Diagram Features of the ConsoleConsole HOW to Turn on the Power HOW to USE the Touch ScreenSole. Important Calibrate the incline system HOW to SET UP the ConsoleConnect to your wireless network Check for firmware updates Create an iFit Live accountHOW to USE the Manual Mode Key from the console When you are finished exercising, removePower cord. Important If you do not do Measure your heart rate if desiredHOW to USE AN Onboard Workout Select an onboard workoutStart the workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workoutHOW to USE AN Ifit Live Workout Start the workout. See onHOW to USE the Equipment Settings Mode Calibrate the incline system of the treadmill HOW to USE the Maintenance ModeExit the maintenance mode Find keycodesSet up and manage a wireless network connection HOW to USE the Wireless Network ModeEnable Wi-Fi Exit the wireless network modeHOW to USE the Stereo Sound System HOW to USE the Internet BrowserHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Lower the Treadmill for USETroubleshooting Symptom The power turns off during useSymptom The walking belt slows when walked on Top ViewPage Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches Part List Qty DescriptionDescription Qty Exploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT