ProForm pftl101110.0 user manual Start all four Bolts before tightening any of them

Page 10

7.Remove the band securing the Upright Wire (73) to the right Upright (85). Have a second person hold the console assembly near the right Upright. Connect the Upright Wire (73) to the wire harness on the console assembly. See the inset draw- ing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNEC-

TORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors into the right Upright (85).

8.Remove the band securing the TV Cable (112) to the left Upright (85). Connect the TV Cable to the cable extending from the console assembly. Then, insert the cables into the left Upright.

Next, insert the brackets on the Handrails (70) into the Uprights (85). Make sure that no wires are pinched.

9.Attach the console assembly to the Uprights

(85) with four 3/8" x 1 1/4" Bolts (72) and four 3/8" Star Washers (67) (only one side is shown).

Start all four Bolts before tightening any of them.

	7
	Console
	Assembly
	73		73
	85	Wire	73
	85	Wire	Wire
		Harness	Wire
			Harness

8
		Bracket
Console	Cable	70
Assembly		112
		85

9
85	67	72	Console
		72	Console
			Assembly

10

Image 10

Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. PFTL10110.0 Serial No On the WEBTable of Contents Important Precautions Page Power Lines Ground Standoff Service Clamp Before YOU Begin Make sure that the power cord is unplugged AssemblyFirmly tighten the Bolts Is more stable. Do not fully fold the Frame Until the treadmill is completely assembledRaise the Frame 55 to the position shown Start all four Bolts before tightening any of them Attach the Left Upright Sleeve not shown in the same way Make sure that no wires are pinched. See Ohm Flat Wire HOW to Connect AN AntennaOhm Catv Cable HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console This manual. iFit cards are also available at select storesHOW to Turn on the Power HOW to USE the Manual ModePage HOW to USE a Preset Program Start the walking beltHOW to USE a Pulse Program Caution If you have heart prob See on HOW to Create a Custom Program HOW to USE a Custom Program HOW to USE AN Ifit Card HOW to USE the Stereo Sound System Information Mode Press the Power button again and add or remove channelsOptional Chest Pulse Sensor HOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Important The treadmill is not TroubleshootingProblem The power turns off during use Compatible with GFCI-equipped outletsKey and Unplug the Power CORD. Using Problem The walking belt slows when walked onUnplug the Power CORD. If the walking belt TopProblem Television reception is poor Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches R0110A Qty DescriptionQty Exploded Drawing A-Model No. PFTL10110.0 R0110A Exploded Drawing B-Model No. PFTL10110.0 R0110A Exploded Drawing C-Model No. PFTL10110.0 Exploded Drawing D-Model No. PFTL10110.0 R0110A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT