ProForm pftl101110.0 user manual Assembly, Make sure that the power cord is unplugged

Page 7

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call 1-800-445-2480. Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the pack- ing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walk- ing belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lu- bricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key

and your own Phillips screwdriver

, rubber

mallet

, and adjustable wrench

.

 

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it is preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assem- bly. Extra hardware may be included.

3/8" Nut (20)–2

5/16" Star

3/8" Star

5/16" Base Extension

Washer (110)–4

Washer (67)–4

Nut (91)–4

#8 x 3/4" Screw

#8 x 1" Tek Screw

 

#8 x 2 1/4" Screw (63)–4

(7)–6

(82)–8

 

 

3/8" x 1 1/4" Bolt

3/8" x 1 3/4" Bolt

 

5/16" x 2" Bolt (87)–4

(72)–4

(109)–2

 

 

1.

Make sure that the power cord is unplugged.

1

 

 

 

 

With the help of a second person, carefully tip

 

 

 

 

 

the treadmill onto its side as shown. Partially fold

 

 

Bracket

 

 

the Frame (55) so that the treadmill is more sta-

 

 

85

 

ble. Do not fully fold the Frame until the

 

 

 

 

treadmill is completely assembled.

87

 

110

 

 

Insert a Base Extension (97) into the indicated

 

 

 

bracket on the base of the Uprights (85). Make

 

 

 

 

 

sure that the Base Extension is turned so the

 

 

 

 

 

Base Foot (81) is on the side shown. If neces-

 

 

 

91

 

sary, use a rubber mallet to align the holes in the

 

 

 

 

Base Extension with the holes in the bracket.

 

 

97

 

 

Attach the Base Extension (97) with two 5/16" x

 

81

 

 

2" Bolts (87), two 5/16" Star Washers (110), and

 

 

 

 

two 5/16" Base Extension Nuts (91) as shown.

55

 

 

 

 

Firmly tighten the Bolts.

 

 

 

 

 

7

 

 

 

Page 6 Page 8
Image 7
Page 6 Page 8
Contents On the WEB QUESTIONS?Model No. PFTL10110.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Power Lines Ground Standoff Service Clamp Before YOU Begin Make sure that the power cord is unplugged AssemblyFirmly tighten the Bolts Until the treadmill is completely assembled Is more stable. Do not fully fold the FrameRaise the Frame 55 to the position shown Start all four Bolts before tightening any of them Attach the Left Upright Sleeve not shown in the same way Make sure that no wires are pinched. See Ohm Flat Wire HOW to Connect AN AntennaOhm Catv Cable HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt This manual. iFit cards are also available at select stores Console Diagram Features of the ConsoleHOW to USE the Manual Mode HOW to Turn on the PowerPage Start the walking belt HOW to USE a Preset ProgramHOW to USE a Pulse Program Caution If you have heart prob See on HOW to Create a Custom Program HOW to USE a Custom Program HOW to USE AN Ifit Card HOW to USE the Stereo Sound System Press the Power button again and add or remove channels Information ModeOptional Chest Pulse Sensor HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Compatible with GFCI-equipped outlets TroubleshootingProblem The power turns off during use Important The treadmill is notTop Problem The walking belt slows when walked onUnplug the Power CORD. If the walking belt Key and Unplug the Power CORD. UsingProblem Television reception is poor Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Qty Description R0110AQty Exploded Drawing A-Model No. PFTL10110.0 R0110A Exploded Drawing B-Model No. PFTL10110.0 R0110A Exploded Drawing C-Model No. PFTL10110.0 Exploded Drawing D-Model No. PFTL10110.0 R0110A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents