ProForm pftl101110.0 user manual Attach the Left Upright Sleeve not shown in the same way

Page 11

10.See drawing 10a. Remove the indicated #8 x 3/4" Screw (7) from the right Handrail (70).

See drawing 10b. Slide the Right Upright Sleeve (9) up to the console assembly. Attach the Right Upright Sleeve with two #8 x 1" Tek Screws (82) and the #8 x 3/4" Screw (7) you just removed.

Attach the Left Upright Sleeve (not shown) in the same way.

10a

70 7

10b Console

Assembly

7

9 82

11. With the help of a second person, carefully	11
lower the Uprights (85) to the position shown.	11
Attach the Right Base Cover (86) with three #8 x
3/4" Screws (7) and two #8 x 2 1/4" Screws (63).
Start all five Screws before tightening any of	85
them. Be careful not to overtighten the	85		7
Screws.			7
Attach the Left Base Cover (88) in the same		88
way.		88	63
With the help of a second person, carefully raise		7	63
the Uprights (85) to the vertical position.	86	7
	86
		63
12. Note the location of the 75 ohm terminal on the	12
treadmill. For the television to operate, an RCA	12
component video cable must be connected to
the audio/video input jack on the back of the con-
sole or a CATV cable or an antenna must be
connected to the 75 ohm terminal (see page 13).
			75 Ohm
			Terminal

13.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place. The hex key is used to adjust the walking belt (see page 30). To protect the floor or carpet from damage, place a mat under the treadmill.

11

Image 11

Contents On the WEB QUESTIONS?Model No. PFTL10110.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Power Lines Ground Standoff Service Clamp Before YOU Begin Firmly tighten the Bolts AssemblyMake sure that the power cord is unplugged Until the treadmill is completely assembled Is more stable. Do not fully fold the FrameRaise the Frame 55 to the position shown Start all four Bolts before tightening any of them Attach the Left Upright Sleeve not shown in the same way Make sure that no wires are pinched. See Ohm Catv Cable HOW to Connect AN AntennaOhm Flat Wire PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord This manual. iFit cards are also available at select stores Console Diagram Features of the ConsoleHOW to USE the Manual Mode HOW to Turn on the PowerPage Start the walking belt HOW to USE a Preset ProgramHOW to USE a Pulse Program Caution If you have heart prob See on HOW to Create a Custom Program HOW to USE a Custom Program HOW to USE AN Ifit Card HOW to USE the Stereo Sound System Press the Power button again and add or remove channels Information ModeOptional Chest Pulse Sensor HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Compatible with GFCI-equipped outlets TroubleshootingProblem The power turns off during use Important The treadmill is notTop Problem The walking belt slows when walked onUnplug the Power CORD. If the walking belt Key and Unplug the Power CORD. UsingProblem Television reception is poor Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Qty Description R0110AQty Exploded Drawing A-Model No. PFTL10110.0 R0110A Exploded Drawing B-Model No. PFTL10110.0 R0110A Exploded Drawing C-Model No. PFTL10110.0 Exploded Drawing D-Model No. PFTL10110.0 R0110A Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty