ProForm pftl101110.0 user manual HOW to Connect AN Antenna, Ohm Catv Cable, Ohm Flat Wire

Note: Due to an FCC requirement, analog signals will no longer be broadcast over the air after June 12, 2009. If you wish to view television signals through an antenna after that date, you must have an antenna ca- pable of receiving digital signals or a digital converter box. Cable television will not be affected.

Before operating the television, you must connect an antenna or a 75 ohm CATV cable to the 75 ohm ter- minal or an RCA component video cable to the audio/video input jacks. Note: Use a CATV cable to connect to an external source such as a cable box, satellite TV box, VCR, or analog cable. No RCA component video cable, CATV cable, antenna, or adapter is included.

HOW TO CONNECT AN ANTENNA

Place an indoor an-			Outdoor
tenna or an outdoor		Indoor
combination			Combination
VHF/UHF antenna		Antenna	VHF/UHF
in the desired loca-			Antenna
tion. Outdoor anten-
nas are subject to
weathering that can
reduce signal qual-
ity. Inspect your out-
door antenna and
the lead-in wiring
before connecting
the antenna.
75 Ohm CATV Cable
1. Connect the 75 ohm
	CATV cable from the	75 Ohm CATV Cable
	antenna to the 75
	ohm terminal on the
	treadmill frame near	75 Ohm Terminal
	the power cord.
300 Ohm Flat Wire
1.	Connect the 300	Screwdriver
	ohm flat wire from			300
	the antenna to a
	300 ohm to 75 ohm			Ohm Flat
	adapter.	300 to 75		Wire
2.	Connect the 300	Ohm Adapter
	ohm to 75 ohm	300 to 75 Ohm Adapter
	adapter to the 75
	ohm terminal on the
	treadmill frame near	75 Ohm
	the power cord.
		Terminal

HOW TO CONNECT AN EXTERNAL SOURCE USING A CATV CABLE

1.Connect one end of a 75 ohm CATV cable to the 75 ohm output jack on your external source.

2.Plug in the power cord of your external source. See your external source userʼs manual for proper grounding instructions.

3.Connect the 75 ohm CATV cable to the 75 ohm terminal on the treadmill frame near the power cord. See the drawing at the left.

HOW TO CONNECT A VCR OR DVD PLAYER USING AN RCA COMPONENT VIDEO CABLE

1.Connect the three-pronged end of an RCA compo- nent video cable to your VCR or DVD player.

2.Plug in the power cord of your VCR or DVD player. See your VCR or DVD player userʼs manual for proper grounding instructions.

3.Connect the RCA component video cable to the audio/video input jack on the back of the console.

13