Locate the Reed Switch (22) and the Magnet (18) on |
| Top |
|
the left side of the Pulley (17). Turn the Pulley until the |
|
| |
Magnet is aligned with the Reed Switch. Make sure |
| View |
|
that the gap between the Magnet and the Reed |
|
| 17 |
Switch is about 1/8 in. (3 mm). If necessary, move |
| 22 | |
the Reed Switch slightly using a slotted screwdriver. |
| 18 | |
Reattach the Motor Hood (not shown) with the #8 x |
| 1/8 in. |
|
3/4" Screws (not shown) and the #8 x 3/4" Tek Screws |
|
| |
(not shown). Run the treadmill for a few minutes to |
|
|
|
check for a correct speed reading. |
|
|
|
PROBLEM: The walking belt slows when walked on |
|
|
|
SOLUTION: a. Use only a | |||
b. If the walking belt is overtightened, treadmill perfor- | b |
| |
mance may decrease and the walking belt may be- |
| ||
come damaged. Remove the key and UNPLUG THE |
|
|
|
POWER CORD. Using the hex key, turn both idler |
|
|
|
roller bolts counterclockwise, 1/4 of a turn. When the |
|
|
|
walking belt is properly tightened, you should be able |
|
|
|
to lift each edge of the walking belt 3 to 4 in. (8 to 10 |
|
|
|
cm) off the walking platform. Be careful to keep the |
|
|
|
walking belt centered. Then, plug in the power cord, | Idler Roller Bolts |
| |
insert the key, and run the treadmill for a few minutes. |
| ||
Repeat until the walking belt is properly tightened. |
|
|
|
c.If the walking belt still slows when walked on, please see the front cover of this manual.
PROBLEM: The walking belt is
SOLUTION: a. If the walking belt is | a |
UNPLUG THE POWER CORD. If the walking belt | |
has shifted to the left, use the hex key to turn the |
|
left idler roller bolt clockwise 1/2 of a turn; if the walk- |
|
ing belt has shifted to the right, turn the left idler |
|
roller bolt counterclockwise 1/2 of a turn. Be careful |
|
not to overtighten the walking belt. Plug in the power |
|
cord, insert the key, and run the treadmill for a few |
|
minutes. Repeat until the walking belt is centered. |
|
b. If the walking belt slips when walked on, first remove | b |
the key and UNPLUG THE POWER CORD. Using | |
the hex key, turn both idler roller bolts clockwise, 1/4 |
|
of a turn. When the walking belt is correctly tightened, |
|
you should be able to lift each edge of the walking |
|
belt 3 to 4 in. (8 to 10 cm) off the walking platform. Be |
|
careful to keep the walking belt centered. Then, plug |
|
in the power cord, insert the key, and carefully walk |
|
on the treadmill for a few minutes. Repeat until the |
|
walking belt is properly tightened. |
|
30