ProForm PFTL16011.0 user manual

Page 12

12.With the help of a second person, hold the con- sole assembly near the Uprights (90, 99).

Connect the Upright Wire (88) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-

NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER.

Next, connect the two pulse wires. Then, remove the wire tie from the Upright Wire (88).

13.Insert the pulse wires and the Upright Wire (not shown) into the Handrails (92, 93) as you set the console assembly on the Handrails.

Attach the console assembly with four 5/16" x 5/8" Screws (4) and four 5/16" Star Washers (12). Start all four Screws, and then tighten them.

Tighten the four 3/8" x 1" Screws (6).

12
						Console
						Assembly
	Pulse Wires			88		Console
	Pulse Wires

						Wire
			Pulse Bar		90
	99		Assembly		90
	99			Wire
				Wire
				Tie	Console
					Console
					Wire
					88
13
						92
93
12				Console	12
					12

4		6		Assembly	4	6
		6			4	6

12

Image 12

Contents QUESTIONS? Model No. PFTL16011.0 Serial NoCall TOLL-FREE Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Before YOU Begin Part Identification Chart Assembly Make sure that the power cord is unpluggedSee the inset drawing. Tie the wire tie Be careful not to pinch the wires Tighten the Screws yet. Note It may be helpAttach the Right Upright not shown Base Covers into place yetScrews and Star Washers will be Used in step Assembly Assembly. They will be used in stepStart all four Screws, and then tighten them Page Is shown. Start all four Screws, and then Tighten them Page HOW to PUT on the Heart Rate Monitor Care and MaintenanceTroubleshooting Chest Heart Rate MonitorOperation and Adjustment HOW to Connect the Power CordUse a Surge Suppressor Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Touch ScreenHOW to SET UP the Console Connect to your wireless network Check for firmware updatesCalibrate the incline system Create an iFit Live accountHOW to USE the Manual Mode Measure your heart rate if desired Avoid movingContacts your handsTurn on the fan if desired HOW to USE AN Onboard Workout Select an onboard workoutStart the workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workoutHOW to USE AN Ifit Live Workout Start the workout. See onHOW to USE the Equipment Settings Mode HOW to USE the Maintenance Mode Exit the maintenance modeCalibrate the incline system of the treadmill Find keycodesHOW to USE the Wireless Network Mode Enable Wi-FiSet up and manage a wireless network connection Exit the wireless network modeHOW to USE the Stereo Sound System Make sure that the audio wire is fully insertedCool Down Mode HOW to USE the Internet BrowserHOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Symptom The power turns off during useSymptom The walking belt slows when walked on Page Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart List Qty DescriptionDescription Qty Exploded Exploded Drawing B Exploded Drawing C Exploded Drawing D Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT