4.While another person holds the Handlebar (7) near the Handlebar Post (6), feed the Upper Wire Harness (16) and the Pulse Sensor Wire (45) up through the indicated hole in the Handlebar. Attach the Handlebar to the Handlebar Post with three
M8 x 25mm Button Screws (19) and three M8 Split Washers (28).
5.The Console (9) requires four “D” batteries (not included); alkaline batteries are recommended. Press the tab on the battery cover and remove the battery cover. Press four batteries into the battery clips; make sure that the batteries are oriented as shown by the diagram inside the battery clips. Then, reattach the battery cover.
6.Insert the Bookrack (8) into the slots in the Console
(9). Attach the Bookrack with two M4 x 25mm Screws (20). Be careful not to pinch the wires in the Console.
7.While another person holds the Console (9) near the Handlebar (7), connect the Pulse Sensor Wire (45) and the Upper Wire Harness (16) to the corre- sponding wires on the Console.
Insert all excess wiring downward into the Handlebar Post (6). Attach the Console (9) to the Handlebar (7) with four M4 x 16mm Screws (21).
Be careful not to pinch the Pulse Sensor Wires (45) or the Upper Wire Harness (16).
6
4 |
|
|
|
| Hole |
|
| 45 |
| 6 | 7 |
|
| |
28 |
|
|
19 |
| 16 |
| 28 | |
|
| |
|
| 19 |
5 |
|
|
|
| 9 |
Battery |
|
|
Cover |
|
|
|
| Batteries |
6 |
|
|
|
| 8 |
|
| 9 |
20 |
|
|
7 |
|
|
|
| 9 |
| 7 |
|
21 |
| Console |
|
| |
| 45 | Wires |
| 16 | |
|
| |
|
| 21 |
|
| 6 |